Viewing all customer Discussions for:

82-106 Sliding Door Turning Lever

I am told my slider needs its thumb latch replaced. Would your 82-106 fit a JELD-WEN slider?

I lost the lever that locks/unlocks the door. I need to purchse product code 82-227 with the 45 degree lever hole but I need the lever as well and I lost it with the broken mortise locking mechanism. Do you sell the 45 decgree lever to go with this lock

Can the door thumb latch be purchased separately? I have misplaced the one off the original unit. Thanks Don

Latch does not respond properly to handle. When I removed the lock a small spring fell out of which one of the hooks at end of spring is broken. Measurements etc make me believe part 82-218 is the right replacement. Is there a spring mechanism in that lock ? I am assuming that I can just use the ... (cont.)

Need to replace the locking mechanism and lever used to lock and unlock it. Summit Series 8670 AAMA/NWWDA/01/I.S. 2-97 MFR Code: Summit Window JW-2

I am looking for a replacement lock for my patio door. It is approximately 3/4" x 6 1/8". There are no markings on the lock assembly or the door. I have attached pictures.

can we buy the lever only

measurements: wooden handle unit 7 inches long; door frame lock 3 inches long; lock catch on door frame 3.5 inches long installed in 2000

Hello help! I broke the thumb latch (see attached images) of my patio sliding door and need help to purchase a replacement. I don't know the manufacturer of my sliding door but I know it was installed in 2006. If I cannot obtain the part I will be willing to buy a full set including the handle a ... (cont.)

My patio door is 1-3/4 inch thick, with handle bolt holes spacing 3-15/16 inch. Your replacement part number 82-035 appears to match the one I need to replace, the exterior handle has extended bolts - however it is for a 1-5/8 inch thick door mine is 1-3/4 inch. Will it fit my door? ... (cont.)

The broken lock mechanism is gone - we have tried several that looked like they should fit but were too big - any ideas?

Hey guys...am trying to include images of the door "handle lever" that is only 5/8" in length...way too short...I need longer by at least 3/8"(I think) Thanks, Bert

could you please supply this part for a certainTeedpatio door handle .it is the interior latch that locks the door,thank you

Good afternoon, I'm looking for a door handle/ lock for my sliding glass door attached are pictures of what I have and a drawing of the dimensions of the lock. The handle holes are 5.25 on center

Hi dear, I m sending picture of my old lock it is not working any more , I need to buy new from you if u have one so pls guide me ejectly same pls I want purchase it ,thanks

I bought a replacement 82-218 (Mortise lock) and 82-106 (turning lever), but the turning lever is not long enough to reach into the mortise lock mechanism. Does your company sell a turning lever with a longer shaft?

I bought the home in 2008 and the builder is D R Horton. I could not locate any info on the door. I have attached pics.

I'm having trouble locating a replacement handle to a sliding glass door. The thumb lever (which sets the lock) snapped off. The door was installed in 2003 by a local dealer who was using Empire Pacific products; the Empire Pacific products apparently were bought out by a Portland, Oregon, installer ... (cont.)

This lever locks and unlocks the slider. There are no markings on the door or hardware , other than the glass manufacture. Thank you John

Hi, We seem to be missing the lock portion of the handle on our sliding glass door. I just want to replace the lock on the handle, or do we have to replace the entire handle? Thanks, Hayley