Viewing all customer Discussions for:

84-006 Sliding Screen Door "M" Spring Tension Roller

1" inch M shaped spring roller roller

Hi, I need a replacement for the attached screen roller. The measurements are: Metal spring width 11/32 inches, Wheel diameter 1 inch, Wheel width 1/4 inch, Guide pin diameter around 1/8 . It looks like your item 84-084 but it has a guide pin.

I submitted previous photos about this project. I ordered 4 - part # 84-106.I replaced the rollers at the top of the door easily.These pictures are for the rollers on the bottom of the door. they seem to be different than the top rollers. There are screws on the edge of the door, but they can't b ... (cont.)

The first two photos are of the top of the door, the 3rd and 4th are of the bottom. The bottom 3rd pic does not rotate, the 4th does turn but does not protrude below the door. The top rollers are fine. But there is no screw holding them in place. They seem to be in a slot in the frame. I don't ... (cont.)

Can not find correct roller for my 1900 series patio door screen. Please help

The metal part that allowed this wheel to stay in the bottom of the door broke off. It's a sliding screen door. The actual door says "The Atrium Door" on the hardware. Not sure if that's an Anderson type (have older Anderson windows). Is this a part i can buy and if so, how much for 2? Might as ... (cont.)

Hi I'm trying to figure out what type of wheel roller goes to my screen door. I can't find a manufacturer name on the door itself and can only see patent no 3,090,0?? Any assistant in identifying this part would be appreciated or the type of screen roller it is to look up How to property remove it ... (cont.)

broken roller removed from our patio door screen.It broke just next to wheel. Will the 84-006 with locator pin work for replacement? our wheel is 1" diameter. metal spring is 5/16" wide. It was very hard to remove from door. See picture.

Bottom roller of sliding door screen

For Screen Door Roller, 1" Steel BB Concave Product Code: 84-074 How does this part attach to the frame?? Do the two holes on the top ends accept screws or bolts and if so do them come included? How high is the part of the 84-074 which must fit into the frame for this to work (ie how de ... (cont.)

New problem. I attempted to insert one of the spring roller units in the bottom rail of the door and encountered a problem. Never could get the leading edge (with the pin) of the unit inserted far enough so I could place the curve on the unit into the channel of the bottom rail. Something wa ... (cont.)

How do you replace it ? Which one is easiest to use? the one with the rivit on the end or the one with the hole on the end?

My current sliding screen doors have 84-006 type rollers which don't roll easily and the spring often breaks. I would like to use ball bearing rollers and it looks like the 84-031 type would work except for the locator pin. Could I drill those out? Would the 1/32 difference in spring width be an iss ... (cont.)

How do you remove the old M spring roller? Thansk

i have a sliding screen door that uses the screen door roller 84-006s. do you sell the bottom track. it is 6 foot, and is a metal track that is about 3/4 wide with a plastic section that snaps over it with a raised center spline that is about 1/4 high on which the roller rides. i don't know the door ... (cont.)