Viewing all customer Discussions for:

84-020 Screen Door Roller, Fits Andersen

Hello. i have two screen doors in bad condition . One was broken but i could repair if i find the right angles and both are missing their rollers ( 2 single roller on each door) . See pictures . Any idea if i can get thoses pieces.Thanks in advance.Gaetan

Hello:We have an Anderson sliding screen door PD3068 size 35 1/2" x 77 1/4". We have to remove the top tension spring because it makes the door stuck on one spot, even the spring fits well on the designate slots. I think the metal of the springs are too stiff. We like to put the tension springs ba ... (cont.)

I need this part

Glider wheel on the bottom of the sliding screen door. Anderson model PS11 6R OPER.

I have a sliding screen door, unsure of manufacture, that needs two new rollers on the top of the door. There are two sets of holes on the top that are 4 1/2" apart that I assume are for the rollers? Would you have any idea what part would work for this? Sorry about the limited information. Thank Yo ... (cont.)

ps11 6l rollers, door is hard to open and close. Haven't tried adjusting yet if adjustable.

The replacement door part # is 2505930. Looking for the two bottom rollers

We were told you might have replacement parts for our generic sliding doors? The wheels and the springs, as well as the door hankdles are missing this spring Our door handles are 4 inches long Our width of slider is 5/8 inch

Looking for wheel assemblies for anderson patio screen door Thank you Steve

Looking to replace two of these rollers. Has a metal housing with a nylon roller and a nylon gear type adjuster shown here broken away from the top opening.

I hae a Anderson patio door which was installed in 1989 and the door is very hard sliding I have adjusted the ollers at the bottom of the door using screwdriver into plastic roller adjusters doesn't seem to lift door enough

I need to replace these rollers on my screen doors... By chance do you also have new replacement screws as the ones in the doors have been rubbing the track and are now worn out and need to be replaced also Thanks

the main sliding door is a anderson, one of the rollers is riveted the other has two screws

Looking for a replacement. Door was manufactured prior to 1991?

Re: Andersen Patio Door and Screen. -Purchased 84-020 which was exact match for screen door. -Purchased 84-005, which was shorter than top of door roller on screen door. Mine is about 3 1/4" and has (2) holes in stem. Can probably make work, unless you have exact match. -Purchased 81-128 P/Doo ... (cont.)

Patented 1967 Can. Patent No. 3.237.238, however, my part does not match current image found on your web site for this Patent No. Home was built in 1973. No markings found on actual sliding patio screen door itself. Please see attached pics (sorry, a bit blurry)

I need new rollers for my Anderson screen door that has been installed upside down since the house was built. It looks to me like I need the 84-078 but I can't tell what bottom rollers I need. I have attached pictures of both top and bottom rollers. Can you please advise wich rollers I need? Tha ... (cont.)

There are 2 numbers on the glass, not sure which one is the model number. NFRC 013/014 High Perfermance 1GCCRCBA 1GMAC CIG 37-01 I need to replace the wheels on the bottom of the screen, the wheels have a roller that fits on a track to keep the door in place.

I bought this house and the rollers were missing from this sliding screen door.

Does your replacement roller that fits the sliding Anderson screen come with the screws?