Viewing all customer Discussions for:

87-061 Acorn Slider Roller Assembly, 5/8" Flat Wheel

I believe my aluminum sliding window used a pair of tandem rollers. The assembly looks to be 1 5/8 " long and between 5/8 and 3/4 " wide

Hello, I have old acorn windows and during storms the whole track fills with water as seen in the images.. This is just the remainder 2 days after soaking the rest out. When the whole cancel was filled. Curious how to prevent this from happening and if I'm missing a necessary part. ... (cont.)

Hi, I'm looking for parts to help fill the gap/stop the draft and outside world getting in on what I think is a set of acorn 2500. The third picture shows what I think is some draft stopper attached to the top of one window, but the others are missing it. Similarly on the bottom, any suggestions? ... (cont.)

Looking to replace wheels in Acorn slider windows. The bracket assembly is still good in most of the windows. I have used the 87-061 assemblies and sometimes just pop out the wheel to use in the old bracket. It is an easy repair without breaking down the window frame. Is the 5/8 roller wheel av ... (cont.)

As you can see they are in disrepair and needing replaced (the roller falls right out). Can you help me find replacement roller please? They are 1 3/4 inch long, 3/8 inch wide. Not sure how wide they are at the widest point in the assembly where it wedges into the frame. Thank you so much for your h ... (cont.)

Please see the attached picture taken by my customer. Unfortunately, I do not have any measurements to help locate a replacement. This is for a sliding window located in a condo complex. Is there any information you can provide on a possible replacement.

I need these replacement rollers but can't seem to find the right ones.

Hi! :blush: The manufacturer of our windows is Acorn. I can't seem to locate replacement locks. Can you tell me if you carry this type of lock? I have several that need replacing. I appreciate your time with this. Karen

I have attached detailed pictures with measurements above. I need 6 plastic housing rollers with metal wheels. Thank you.

My home has ATERM sliding windows. All but 2 slide open from left to right when unlocked in the lower right. However, 2 windows do not slide open. Each of these windows seems to be held up from sliding from the bottom right corner as if the window were locked. I have unscrewed and removed the lockin ... (cont.)

I have Atherm sliding windows that need rollers. Do you have this option?

I am a repeat customer of yours. I need help in identifying a wheel for one of my customers. He would need about 10 or so. I have attached (2) pics. The width of the wheel is 1 11/16 long x 3/4 wide x 3/4" tall (including wheel) - The wheel appears to be 5/8" in diameter. If you can plea ... (cont.)

The plastic bushings for these windows appear to be about 1.75 inches in length and about 0.75 inches in width. The highest height of the bushing is 5/8 of n inch and the metal wheel itself has a 5/8 of an inch diameter. See the attached photos. The building has 178 units and a lot of the tenants ... (cont.)

Is the ball bearing wheel available separately from the nylon housing for the 87-061? 5/8 diameter x 1/4 wide wheel with 1/4 axle 1/2 inch long.

I have looked at the guides on your site and I am not able to tell which one would replace this. Are you able to help me? The length of it is 1 11/16".