Viewing all customer Discussions for:

87-143 Sliding Window Roller

I measured 3/8" x 1&3/4"

Insert is of photo, wheels areoff as they are broken. rough whhel dimension 1-1/16 in. insert opening in screen is 2-1/4 in wide. roughly 1/2 inch inside dimesion if insert I can go as far as 1- 1/4 inch deep

Please find the photo attachments below and hope you have the part available.

Parts for TRACO sliding Windows

Hi, I have a window that uses a longer version of 87-190. The dimensions are identical except that it is 2 1/16" long instead of 1 3/8". Is there a product like this? If not, have people used anything to fill the gap?

I have vinyl glider windows wit two sets of brass roller for each window. The rollers have worn down. I have attached the dimensions. The nylon housings appear to be in good shape the rollers are 9/16 with a 3/8 pin

There is 1 roller and its plastic goes on a custom made slider on my porch.1/2 inch x 2 amd 1/8 long x 3/4 deepMike

Good dayI am in need of assistance in acquiring these wheels my windows. The current wheels are corroded but the windows are still good. Alternative options are welcomed and appreciated. Thank you for your assistanceAngie Length- 1 3/4Width- 3/8Height- 5/8Width Top - 5/8

https://www.swisco.com/Sliding-Window-Roller/pd/Sliding-Window-Rollers-With-Plastic-Housing/87-143 Maintenance says they need the larger wheel that fits into the part referenced above. What is the wheel part number? Thank you!

I would like help finding replacement wheels for above window identification tag. I have little brass wheels that are dual wheels

My current roller are plastic housing and metals wheels. They are 3/8 wide and 1/2 tall. What's proper ones to order

All the rollers have gone flat so windows drag. I plaxed a order and they are to large

I am trying to find a matching roller assembly for a Traco slider window. These windows were installed in the mid-1980s. The assembly is very similar to your 87-143 with the following differences:Assembly length is approximately 1-3/8 in.There is no middle rib on the 'bottom' roller side. There is ... (cont.)

Do you have, or can suggest somewhere, I can procure replacement wheels for sliding window roller part #87-143? I believe this part has a Wheel which is is 17/32x3/16 with a 3/16 inch axle. Need for replacing on Traco windows. Your part 87-143 measures as a replacement assembly but just need wheels. ... (cont.)

Searching for 900-115644Would you have a smaller version of your product code 87-143. All the dimensions are same except the 1 3/4". The one I have is 1 3/8". Attached is the picture of a Traco sliding window roller.Greg

Hello, I'd like to use my "in store" credit to replace 2 pairs of Sliding Window Rollers. They are to replace rollers off of some Traco windows that are similar to rollers I found on your website with the product code: 87-143. My rollers measure about 1 3/4 x 3/8 so I'm pretty sure 87-143 would fit. ... (cont.)

I can't get the lock to line up with the catch. Is there an adjustment on the window? thanks, Gabe

I need to find this piece for my sliding windows.