Viewing all customer Discussions for:

90-005 Window Sash Lock, 2-1/4"

Hello, I am looking for a window lock for Sunair window. Please see photo attached. Thank you!

Can you help me identify this broken window lock and find a replacement? Thank you

Hi, I have a need to replace Viking window latches. Thanks, Damon

I have several Viking window locks like those in the attached photo. I would like to order at least 3 and perhaps 5 to have extras on hand. Do you carry these and, if so, how much to they cost? What is the lead time?

What is the difference between the 90-005 and the 90-009? I think I have the 005. The original I have is has Alenco cast into it.

I am trying to match the single hung MI 455 series. I was told to contact you from our MI representative.

I have Marshall windows that were installed in the early 90's.....quite a few have broken off and I want to replace them ASAP. The dealer I went through does not honor their " lifetime" warranty ,so I'm on my own! Don't really know what I'm doing,but was hoping for a little guidance from your knowle ... (cont.)

I need about a dozen Locks are 3/4" wide X 2 3/4" long Identifying number on window frame: Mfg code AB1, DH R25/DH 30 series 500-601 Can you help? Larry

Hi I'm a realtor in Vegas and need 8 alenco window locks..... Please see attached photos thank you 2 3/4 in length by 3/4 " in width

Please tell me the name of this lock

The latches on the window locks are broken and i am looking for replacement locks to secure the windows. CHAMPION Windows

I need to replace the sweep lock for a Champion window. The attached pictures tell most of the story. The screw holes are 2-1/4" apart. The height of the portion that goes into the upper window measures 3/16" at its highest point, but frankly it is hard to get it to go all the way into the window. ... (cont.)

The window opens vertically pushing up to open from the bottom up. The actual label from the window frame has the following information on it. AAMA HS-R20 - also has MST-10050; included on the right side of the label is ANSI/AAMA-101-88; Series 8000 and MVI Manufacturer's code. The latch that s ... (cont.)

I have attached a sample of the lock that I need for my Marshall windows; I need about 40 pieces. You may reply via email preferably. Thank you. Silva

I need replacement locks for the attached General Aluminum lock. Installed 1993.

I have Alenco windows, circa 1992. The rollers on the sliding windows no longer roll, and need replacing. But, how do I get them out? The whole window won't lift up enough to take the window out. Can I simply unscrew the screw in the picture and pull the roller assembly out - perhaps with need ... (cont.)

We are an apartment complex trying to locate a window clip that prevents window from falling into the apartment. TRACO A Three Rivers Aluminum Co.

I'm looking at your 90-005. We have Viking Tempseal Windows. Our locks are left and right. I know this would work in either direction, but do you sell this in left and right. Chris

Hello, I am trying to source replacement parts for my Marshall windows as follows: 1- they have sweep locks and they seem to be fine, but there is a plastic spacer underneath the lock that is falling apart due to sun and heat exposure. Do the locks on your site - #90-005 would be the one I thin ... (cont.)

I am looking for a window lock like your product code 90-005. I need a 1/2" projection. Can you provide that? Need 4 to 6 pieces in black (or white as a second choice). Thanks, Gary