Viewing all customer Discussions for:

95-002 Capitol Window Panel Corner, 3/16" x 3/16"

Please see attached picture of a screen corner that I believe is for a discontinued aluminum window. Please let me know if you have a substitute that will work to replace this corner with a slot.Vicki

1219620611

Hello, I have a window screen that measures 18-1/2" high (top to bottom) and 30-1/4" wide with sliding locks in the frame as shown in the attached photo. The sliding lock on the right side of the screen frame is broken. I have attached a photo of that as well. The sliding lock measures 3/8" high ... (cont.)

Do you know where I can find these?

Hello,I'm looking for several corner keys pictured in attached photo. They are from Ideal Window Co. Note the slot cut on one side.Can you help?Thank you,Tim

Hello I am looking to see if you have this part or are able to get it for me. The size is 1 3/4 inch either 3/16 or 7/32 thick. Could you please let me know if you have it or can get it for me?

The original corner swivel I removed is horizontally 3/16 wide x 3/16 deep and 1 1/4 long to the swivel. The vertical is 1/8 thick and Looks to be 3/16 wide. It does not appear to be offset, although the two sides are slightly different at the swivel. The number 400 is stamped on one side.I assume t ... (cont.)

Screen corner is 1/4" thick. It has to have the slots to go into frame.

1 3/8 long by half inch wide by 3/16 thick I do not see this on your site, do you offer a replacement?Just remeasured the thickness of the caliper 210 Thousands

Hi can you help me find which window screen corner is a replacement for this picture. It is from Silverline windows. Thank you!

Trying to replace this plastic corner connector. Would you have this part?

Are you able to identify these slide bolts?

My old storm door sliding window panel corner key is broke. I am unable to take it apart (until I fix it) and do not want to make it worse. Your website does not list lengths for most of the corners, and mine is approximately 1 3/4" long. It is approximately 1/8" to 3/16" high. I do not know the ... (cont.)

I have a broken corner screen white that's 1/2 inch wide with a center slot. the length on one side is an inch and a half with 5 top side cuts. Hopefully you know what I need thanks

Gentlemen,I am in need of corner keys, Silverline screen turn clips (I think), and hollow pull tabs to repair a number of screens.The corner key is 3/16" thick by 1/4" tall on each leg. Leg length is ~ 1 1/4" long (outside measurements)Also, I plan to replace the fiberglass screen with aluminum. ... (cont.)

the one on the white background is missing a "finger." The bottom section is one solid piece and the vertical side has 2 fingers that are split. These are for extruded window screen frames.The blue background is a plastic corner from lip frame window screens.the edges have actually all broken off of ... (cont.)

Could you help me identify this corner? I would also be looking for the top corners to match if they are not identical. I cannot tell; the tops are to deteriorated to remove. The are turning into dust.

Hi, I am looking for these end pieces. There doesn't seem to have that hole to release the spring and latch as in your video. It seems like the corner piece is holding the spring and the latch in. I broke part of the corner piece on the other side. So I could also use some help with how to to get bo ... (cont.)

I need to find a replacement for these screen corners. The outer diameter is 5\16 by 3\4".

This is a picture of a broken screen window broken corner. Looking to learn the company as I need the locks as well. I am looking for 2 to 3 dozen of these pieces. Thanks for your help