Viewing all customer Discussions for:

S380-30 30" Series 380 Channel Balance

The length is 29" ( 30 actually) and writing on the part is 29 3 BX CMC 10 Thank you very much, look forward to hear from you

Window guides// the steel is 30" , the at the bottom is 1", the steel is 1/2"? thank you!

Hi, I bought previously from you and it had a windows marking of 2630. But I bought a longer version elsewhere. The shorter version from swisco is S380-27 : 27" Series 380 Channel Balance. I need this same version with metal channel of 29 15/16" full length of 31. Can you direct me the correct p ... (cont.)

Hello, I have a window balance that broke and I am trying to find a replacement. The balance is 30 inches. Thank you!

I was wondering if I can get a price on two sets of channel balancers. They are 3/4" sq. X 30"l. The frame has a "b2940" stamped on it. I believe the windows are mfgd by Alcan. I'm guessing around 1992-1993. Thank you, Kevin W.

See photos for marks. These are about 20 yrs old. I need 10 of these with the winged ends. Also need the plastic caps that go on the window since that is what broke and popped these out.

Looking to identify this balancer. Has a 2960 BS1 stamp on it. It is 1/2" guide. Not sure the difference between the S350-S395 are?

Hi ! Awesome service, btw. This is a half inch balance that is 30 inches long. As previous customer, I replaced top sash guide in same window with your part 18-166 (if that helps). Units in pictures is inches.

Metal is 30" long

Please help identify the window balance (the whole assembly) The length of the metal housing is 29 7/8" The marking on the metal housing is "29-5 HA2 CMC 7" Thank you!

I have 3 the same windows 30" channel balance 29 5 EW CMC 10 stamped is there only 1 per window? What side does it go on. Does the window come out? Can you send me how to install it

Thanks for your help in getting me the correct parts. 30"rod, stamp = 2950. Metal framed non-tilt windows, will need 2@ = 4

I'm trying to verify a replacement part for my non tilt window balance spring. It measures 30 inches long. I believe it's a half inch. Photos included.

looking to buy replacement balancer - old one self destructed at lower pully.

i am looking for channel balance stamped cmc 29 2ft 4. I am also looking for the top sash guide that connect to the window. thanks

I have two of the same size windows that need new channel balances. From the top and bottom hardware I've determined that it s a Series 380. The shaft is 30", but imprinted on one set it "2906" and on the other "29 9". Both have the same shaft length and hardware measurements, but I don't see those ... (cont.)

I need 2 of these they are 30 inches long metal to metal. Thank you 9DS45

Hello, My channel balance broke; the cable snapped. I'm trying to find the comparable replacement part. The markings on the channel are 29-HV CMC 7 and the window has an identifier of H-C40-54x90. Thank you!

I need 4 block an tackle channel ballances I am hopeful you have what I am looking for. I have more pictures with measurements if you need them. Thank you. Anthony

Metal channel measures 30 inches with 29 9 stamped on the end.