Viewing all customer Discussions for:

S380-30 30" Series 380 Channel Balance

Looking for replacement channel balancers

Good Morning The above photos are from a NUAIR window. Home was constructed in 2006. The length of the balancer Metal to metal not including plastic tips is 30 inches. I looked on line. I see you have balancers in stock. I could not locate the same number stamping on your site as i have on my bala ... (cont.)

They are 29 inches

How do I know which stabilizer? Metal is 30 inches long. See photos

I am replacing the channel balance for an Alcan window. Your part 30" Series 380 Channel Balance, Product Code: S380-30 appears to be the correct part. My window balance is 30 inches long and 1/2 inch wide. The stamp on the old part is 2910. The bottom measurement is 1 inch just like the S380 ba ... (cont.)

Stamp in channel "29 3" then sideways it says BS1 or 8SI ?

I need to replace my window channel balance. It measures 30" metal-to-metal. There's and engraved stamp of 2920 as noted in the photos. Please advised.

Hello can you tell me what window balance to order?

Please send quote and information on needed replacement

Hello, needed to order new window balances for most of my windows. Want to make sure I'm ordering the correct size. Thank you.

The balance, not including the nylon ends is 30 inches. The markings indicate "2950". This is from a single hung window. Thanks!

Mine is a vertical push up window. On the fallen balance it writes 29-6 KX CMC 7 which i am not quite sure if that's helpful. And my window brand is Milgard

Balance is a Caldwell 1/2 Channel and 8" in length Hard to read stamped number looks like 12 Caldwell hard to make out.

Hello, I have a non tilt window that needs new replacement Channel balances. The channel balance that came out of the window sides are inscribed with '29 3 FX CMC 11'. Can you advise the best Swisco match for this channel balance along with top and bottom stops that get screwed into the window frame ... (cont.)

Looking to replace 10 years old channel block & tackle window balance 29ds 48l on no tilt high impact windows. What will be the best option? Thank you

I have a single hung Lawson impact window that I need 2 new balancers for, the number on balancer is 29DS48L. The metal part measures 30", the total length is 31" including plastic ends. Non tilt Metal length 29-7/8 Width 1/2"

Hi I need the correct replacement 1/2'' balance sash. I also need to top sash clip guides for the window. Please send correct part numbers when you can.

Hello, The channel metal to metal is 30" Please let me know what is swisco part number to order? Thank you Mike

Hey! I need help finding the right window balance. I know that they are 29-4 (so I know I am looking for 29 inch balances) but I am unsure of the weight. I found block and channel balances on your site have the same clips as mine, but still unsure of the wight and how to figure that out. Both sets o ... (cont.)

Can you please help me identify the right window balance to order? Please see attached photos. The length is 30-inches length and 5/8 inches wide but unfortunately when I was removing it, the parts fell out due to the poor condition. Weight of the window is approximately 30 pounds. ... (cont.)