Viewing all customer Discussions for:

21-065 Bifold Door Top Pivot and Guide Pin, Fenestra

Hello I am looking to try to find the pins shown in the picture. I measured the nylon as best I can and it appears to be 3/8". The overall Pin length is over 5.5". The pin is approx. 3/8" in dia but might be slightly smaller. I am wondering if you could provide input if 21-065 might work or w ... (cont.)

I need to replace both pin assemblies on my closet doors. As they all look fairly similar, could you please direct me to the correct parts, please. pictures attached. Thank you!

Some of my bi-fold doors are missing top and bottom pins. Do you carry these parts?

Built in 1970

Need help with these replacement parts for 1970s metal closet bifold doors. I am attaching some pictures. I have pins, but need caps, springs, and whatever holds the pin in place. Can you help me?

older Slimfold door. Bottom pin is just a pin and there is a clamp piece to hold it in place. I have a number of pins, but none have the screw slots at the top, so I need to replace these. Could it be the 21-001 even though it seems to have more parts to it? Need top and bottom replacementsmaybe ... (cont.)

For Ternes steel bifold doors made approx. 1972. Also need replacement knobs

Hi, my name is Maddy. I have a few metal doors that need new hardware but I'm not sure which one are the right ones and local hardware store does not not carry. can you please advise me on what I will need to make this doors work like new? I will appreciate your help on me placing an order to find w ... (cont.)

I'm checking to see if you have these in stock, I would need two of each and these are for steel bifold doors I think they're called plungers.

It appears that your part numbers 21-001, 21-007, and 21-154 could replace the parts in the attached photographs. I assume the guide pins would also fit the upper and lower door tracks. Could you please confirm all of this before I order? Thank you

Attached are the parts I need. I have a total of 10 bi fold doors i need to replace old parts with new ones. Also i need a 5 foot tack. Thanks

These doors are 25+ years old still in good condition except for the hinge hardware would love to find replacement parts Fenestra Incorporated - Detroit, Michigan U.S.A.

Does the top bifold pin 21-018 come with a cone spring?

Hi, I need this part which should match up with Product Code: 21-065. Please let me know if you can find this part. Thanks! Travis

I have three sets of doors by US plywood. The pins are 5/16 by 51/4 long. The top pivot pin looks like the Fenestra pin and spring. the bottom slide pin is threaded at the bottom of the pin with the nylon peice measureshole size is 3/16, the ring is 5/8, and the end is 3/8. I am not finding the repl ... (cont.)