Viewing all customer Discussions for:

21-078 Bifold Door Pivot Pin Assembly

Hello, I need a bottom pin replacement for a bifold door. I have pulled this one out of another door. If you can give me a call to discuss, I would appreciate it. I was wondering if this was product 21-130 & 21-071You people are terrific! Thank you!

These are for metal bifold doors from the mid-70s your website has a to 21-078 but it's too long. do you have something in the 4 3/4-in range

I have a small linen closet with bi-fold door (Leigh Full-Vu door part #6956) which is most likely original to the building (from 1960's). The door won't glide along the track on the bottom of the floor - it gets stuck where the screw sticks up in the track. The top pins often come out of the top ... (cont.)

We have older metal doors throughout the house and they all seem to have the same problem. The bottom sticks on the track unless you hold the door up while closing. I read that the pin is adjustable but can't see how. See photos. It is the bottom pivot pin

I am looking for a two pivot guide rods for my bi-fold closet door. The door was made by National Bifold doors. You can see in the images the length of both of them. The one above the measuring tape is the top guide rod. The one below the measuring tape is the bottom guide rod. Then there are two s ... (cont.)

We put in new metal pivot rods in our bifold doors, is there any way to level the rod up and down, the bottom left rod needs to be lower st stay in the guide hole....HELP

Hello I am sending photos of doors that I am to repair... if possible. I would like to see if you could check the pics out and determine if you have the parts... but... mainly... look at the pic where the bottom of the door has damage and whether it is worth repairing or not. This is for an elderly ... (cont.)

I need pin caps for sets of Leigh Full-Vu steel bi-fold doors. The part number on the door label is 6956. I need both upper and lower caps for 20 doors. I would like to send pictures but can't figure out how to send to an internet address. Can you help me with these? Thanks, Jim

The top guide wheel is not able to stay up seem to be missing an nylinder and bottom guide wheel is Bent Ned a replacement part Steel Full-Vu Door Leigh Products, Inc.

Product Code: 21-078 Is this easy to install? The previous spring and wheel came off but the pin Is still in the door. Your video was helpful, but only one piece fell out so I would like to avoid having to remove the entire closet door. The bottom left pin that slides, the spring and bottom piece ca ... (cont.)

Here is a picture of the bottom pin. It is the wrong one as it is too small for the groove. It should be 13/32" wide to fit the groove. Can you help?

I need to replace the item in the attached photos. Can you identify the part from the photo. I am having problems with the other hardware on the door;the pivot. From this photo is it possible to say the manufacturer of the other hardware? Regards Graham

I have 8 of these bifold doors and on some of them, the upper and lower pins need sliders. RIght now the pins have no slider guides and are metal on metal. Attached are a few pictures of what the good sliders look like (upper and lower)and a shot or two of where the guides are missing. I am in need ... (cont.)