Viewing all customer Discussions for:

21-256 Cone Spring

Hello, I need some hardware for some Fenestra metal bifold doors. They are interior closet doors that were probably installed in the 1960's. We have quite a few of them in a small apartment building. I'm hoping that you can identify the parts from my photos. I'd like to replace the hardware in one s ... (cont.)

Hello Loren and Swisco Help Center, Could you please help me with getting the following hardware: Qty 1 Kitchen window lock for slider window Qty 4 Bedroom window lock for slider window Qty 1 Set of all hardware (excluding door handle) for Kitchen Closet for left door when looking at front of cl ... (cont.)

Good morning All, We welcome your assistance in identifying this door hardware part. Please also advise availability.

Metal pins are fine but need grommets with inner hole diameter 5/16" and bushing inside diameter 5/16" and pin cap 3/16" inside diameter and come spring 2" high , 5/16" and 3/4" diameter. I will send additional photos to make sure parts will fit. Also are there any videos on best way to insert long ... (cont.)

House built in 50's. Caliper measures 1/4" on cap. So product code 21-018 seems to fit all measurements. Cap on this product says 9/32. Then I also need the top guide pin but the cap appears to be wider. First picture is guide pin. I have looked for a month and I finally found your company! Please h ... (cont.)

Hi, Here are the dimensions for the pins that we need. They are 4' long, the top part of the shaft has a 3/16" diameter, the lower part of the shaft has a 3/8" diameter. The metal dome on bottom has a 7/8" diameter. The top plastic part has a 3/4" diameter. Photos attached.

I am attaching the photos of my metallic closet bi fold door's hardware. Top pivot : refer top pivotphotos 5 inch long, 1/4" dia with a plastic washer or cap to hold the pin top and bottom of frame (on a door- See photo top- 8) And a two metal push nuts with cuts to hold the pin( photo no (1,2 ... (cont.)

Looking for replacement part as described in photo attached. Can't seem to find a match on your site? Please advise. Thanks, Tom

Need pins to hold door on track

I have hardware missing from several metal bifold doors. I have identified the door pivots as 21-005, and the cone springs as 21-256. But can not find the pivot rod clamp (picture attached) and the plastic door pin caps (same as come with the 21-005 door pivot). I have found a label that indica ... (cont.)