Viewing all customer Discussions for:

26-336 Pivot Bar, Simonton

Need both right and left.. also plastic box ? Simonton double hung. Looks like 9808

This piece is piece is used to place the window frame in so it can slide up and down. Located on the left and right side.

I have a bottom sash with both tabs broken off that would normally engage the balance assembly. I believe the balance assembly is still good but I can't seem to get the small broken pieces of the cast aluminum post out of the balance assembly. There seems to be small retaining tabs cast into the br ... (cont.)

Hi could you please help me find this part to repair a bedroom window? Thank you!

Prism window

This part goes in the side of the window and guides its movement and acts as a travel stop. There are two in each window.

The pivot bar wasn't screwed on properly, so As I went to remove the window the pivot bar snapped The # on the top bend of the shoe. On the bottom has a circle withe the # 06 on top and 46 on the bottom . Also says China

Not sure what to call this but it

Hoping you can help identifying and replacing this part for a window. It appears to be a Prism window, which is putatively made by Simpnton. Please take a look and see what you can do. I appreciate the help.

I believe my window is a simonton prism and the pivot. Ads broke off the window

three windows in need of repair

Today I bought item number 26-336 The Simonton Pivot Bar, is this the correct piece? My issue is a falling window it won't stay off when you lift it it falls down

I need help identifying the proper replacement for this pivot bar. Although it has only 2 holes, the 3-hole 3 & 9/32 inches Die Cast 85-5003 seems to fit the description and measurements. The windows were installed in 1996.

Tilt pin for bottom of Simonton double hung window

Hi. I need 2of each. The long one is approx 2.5 inches and window is marked 4000DH The short one window says simonton. Cant measure as it is broken

Looking for window tilt bars for Simonton windows. As you see this one is broken. Hope you can help. Not sure where to look for any numbers. Windows are about 10 to 15 years old.

How do I remove the entire window? Place at 45 degree angle & pull outward once it is lined up with cut out????

My pivot bars look about identical to your product #26-336. The two differences I notice are 1. Mine only has two holes 2. Stamped number 8909 on mine

Hi! I purchased the replacement part pivot bar #26-336 for my window, the tip of that bar doesn't fit the existing pivot shoe; I am looking to replace the existing pivot shoe since it looks like the correct pivot bar for this window is no longer being sold. Could you please direct me to which is the ... (cont.)

I am looking for replacement of pivot bars. Do you carry the pivot bars as shown ? Thanks.