Viewing all customer Discussions for:

75-502 3/32" Drill Bit

Whats the name of the pin

Hallo I already order couple times from you It's great parts I already have selected balancers and want to add couple things Top sash locks (seding picture) And from last order I measured wrong and missy to trim channels canI buy some channel rivets? Thank you Bruno

I have 2 balances I need to repair/replace one is stamped 19 5 and has a BSI stamp on it. the metal channel is 19 5/8" long. the bottom fitting is damaged so I think I need a entire new balance. the bottom fitting has a patent # 6598264. The other one is stamped 25 2 and has a BSI stamp. it just ha ... (cont.)

I am in need of (2) ALCAN 2930 and (8) 3620 Channel Balances - from 1990 Alcan windows. I am also in need of the snap in glazing. The glazing measures 9/16 (instead of the 7/16 that the 55-092 shows) and is 7/32 the same as the 55-092. Additionally, the window locks are 2 3/4 inch (2 1/4 inch center ... (cont.)

Non tilt block and tackle balance

ordered S710-29 , should have been s395 opinion 2840. Do you sell the pop rivets that fit the channel that the 19-005 top and 15-001 shoe uses? Instead of re-ordering and paying for shipping again I would like to use the existing ends from the old channel. Thanks for your help.

Hi, I recently had a window balance pop loose from the sash. I have Milgard, single hung, non-tilt windows. When I removed the balance I noticed that the top portion was damaged (parts of the catch area were chipped off and it was missing the spacer on one side). The top sash guide was also heavil ... (cont.)

I am looking for replacements. The aluminum part is 23 inch long. Looks like 23" Series 370 Channel Balance Product Code: S370-23 Do you have replacement springs. Thanks, Ray

My home has many windows. I have had to replace two sets of channel balances so far, and now I have to replace another set. Previously, I used series 385 tops and shoes because those looked most like the originals. However, the tabs are thinner on the replacements than on the original balances; ... (cont.)

How do I install 19-008 & 15-025 top/bottom shoes into my channel balance. Specifically, what kind of rivet (part number?) do I need? Also is your rivet tool (show on your diy page for small rivets)work for this application? Thanks! Dave