Viewing all customer Discussions for:

23-049 Pocket Door Roller

Need to replace current pocket door roller. Current one is worn out

I'm replacing old pocket doors in my house. House was built in the '70's, so all the hardware is dated. It took me quite a bit of elbow grease to get them unhooked but I did it. I noticed you have what looks like an almost identical roller system. Do you think your replacement will work for me? (Pro ... (cont.)

Can I buy the Pocket Door Rollers only from your Hardware Set 23-049

I am the proud owner of a house built by the owner of a lumbermill who LOVED pocket doors! Unfortunately? They are breaking! This is the same AFC marking and same roller you have twice on your page. So specific, I simply stole an image from a previous post and added two of my own. I understand the A ... (cont.)

Hi. I looking for the by also, the track rail for this rollers. My question is what is the part number for replace it. Please let me know

I am looking for this SFC pocket door roller. Or a replacement that will work with my existing rail

This is off of a pocket door, in a house built in 1965. The metal piece is stamped Glidemaster, Pasadena, Pat. No. 3020582. The plastic wheels are stamped, Cox & Sons, Inc, Pasadena Calif. Photos attached. Let me know if you need anything else. Would you have replacements? Tks!!

Wonder if you have anything close to this style. I have already tried one similar to 23-049, but with the adjustment nut it was too wide to fit into the actual pocket. Thanks

Wheel 22 mm, top of bracket 61 mm, bottom approximately 82 mm. you can see from bottom view left mounting flange has broken off. Help!!

Cox & Son"s marked on the roller. The bearings from the rollers have broken. There are two rollers, one is missing broken not showing in picture. Need replacement for my pocket doors...Thank you,Terry

Hi, you have always helped me in the past hope you can help now. The adjuster is not working. The photo depicts adjuster with 1/2" nut . The branded "Acme" thanks, Jack

This roller is at top of door suspending the door Head roller

I've finally removed this misaligned pocket door and am now faced with replacing these casters. Please return with some encouraging news or advise another option. Thanks and standing by, JP

The wheel broke off of one of the two metal brackets that were on my door. I have a picture of the metal bracket attached. Marking say Strato- Track Incorporated. Elkhart Indiana. 5-LH. Please help me locate a new one or two. Thanks

Hello, This is a single pocket door piece. We are looking to order a new replacements. Thanks, Randi

My name is Cliff. My brother Dennis lives in the house where we grew up. This house was built in July-September 1964. His grand-daughter pulled the door the the side and bent the part as shown above. It has since been straightened, but continues to have difficulty in opening and closing the door ... (cont.)

my pocket door was installed in the 70's and worked well for several years, however I changed doors and purchased new hardware for it. my problem as i see it is the new wheels are to small for the old track. Do they make new rollers with larger wheels, the new wheels seem to be small enough that t ... (cont.)

Good morning, I have a pair of sliding mirrored doors where one of the hanging brackets wore out. Ideally, do you carry this bracket? Regards, Bill

Need replacement hardware for this... Slid Master Cx31 number stamped

Here is one of the two roller brackets that originally supported the pocket door I am repairing. I have it arranged on a strip of paper that represents the 1-3/8" thick door I need to rehang. I have it positioned so that the wheel lines up roughly with one of the two v-tracks that it has to sit in w ... (cont.)