Viewing all customer Discussions for:

23-131 1-1/4" Snugger

Hello, I'm looking for the missing parts for this door. I think it might just be the missing snugger? Or assembly that holds the pin in the track. There appears to be a spring already in the track, and one half of the door is still attached (fixed in place by a screw it appears). Any help would be a ... (cont.)

Missing where both doors on a bifold closet meet when closed on upper channel. Apparently never installed cannot locate part anyplace and was told you might be helpful. Thanks

Hello, I am interested in replacing these broken bifold door parts. Can you please help me identify the parts that I need? Thank you, Diana

My bi fold doors came out of the track. I'm trying to put it back together and am not quite sure how the plastic "slider" for the top and the "snugger" go together.

these parts are for an older set of bifold doors. Do you have anything in stock that will work.thanks for your helpSolon

Sending picture of what I am looking for absolutely no markings on anything one photo installed one removed but missing spring part

I have a 36" bi-fold door replacement track which I just ordered from Swisco and installed. The door opening is about 38" wide so it was installed centered with 1" gap on each end. As you can see from the photos, I have a spring stopper which technically isn't needed (i.e. it wasn't there before). ... (cont.)

Trying to replace snugger that looks like your 23-131. This picture is not the old part which had broken, but a new one that looked about the same. However, this new one will not fit in the door track as the small clips that go into the track will not compress enough to fit. The track area they need ... (cont.)

I have a Monarch mirror bifold closet doors and they are old...1997 is when I built my house. The door snuggers broke and I was wondering if there is replacements for them. I have attached photos of the good ones from another room. Any help you can give me is very much appreciated. ... (cont.)

The right photo shows the spring assembly, it seems to be broken on one side, though it is hard to tell. When the doors are closed, the rollers press against the spring but won't stay closed. I purchased your part 23-130 Top slide guide which looked like the broken part, but clearly is different. ... (cont.)

Purchased four 23-130 white long door stops picture #1 to replace the stop in picture #2 obviously I purchased the wrong part or is there another part needed to make the part is picture #1 work? Can you help?

The track in my door is damaged. I need a replacement and I'm having trouble finding a 32" track.

The corner of rail is cracked. The rail width is one inch, however where the rail is crack it is 1'1/4-3/8". The rail is 35 1/2inches by 1 inch wide and half inch depth. The rail she'll installed in closet door is 7/8". I need the entire rail, plastic rail wheel (7/8) and any other hardware you ... (cont.)

I have a number of 4' double folding closet doors that are original to the house which was built in 1984. I am in need of replacement upper hardware (track hardware) for one of these doors. The U sectioon of track is 4' long. There is no writing on the doors or the hardware except for the two end pi ... (cont.)

Hello, I have two bifold doors that meet in the middle. One has a #23-130 spring to keep it on the upper track, but the other does not. I thought I just needed to add in another 23-130 for the other door, but when I installed it, it turns out the doors cannot close because then the two 23-130's a ... (cont.)

WHERE DOES 1 1/4" SNUGGER FIT IN THE FOLDING DOOR?