Viewing all customer Discussions for:

26-354 Sash Vent Stop

I need replacement parts for several windows. These parts extend a small approximately half inch by 3/8 inch piece out and keep the partially open window from being opened any further from the outside. These parts are in the bottom of the frame on the inside of the house

look at figure that has the patent # and notice that the two ends are not the same: one side is missing a snap in holder.

I am trying to identify the latch/lock pictured here so I can order some replacements

Hello, I need two of these stoppers, ie pop up stoppers that block the lower window to be raised pass that point. In the attached picture, you will see that the pop up plastic pieces are missing. I will likely need the whole unit with the pop up plastic. Thanks

This part broke on my sliding window. I need help identifying it and where it can be bought. It has a patent # 5,553903

I knew I would break one eventually, although it took me almost 11 years. This is the popup stop, that when popped out, prevents the horizontally sliding vinyl windows from opening more than 4 7/8". The visible external measurement of the part is 2 7/16" X 3/8".

Good morning.I have Owens Corning fiberglass windows that need replacement parts.I have attached a picture of the serial number for this window.In addition to Spiral balance and pivot shoes, I additionally need a charge tool and replacement vent latches. I cant seem to find a vent latch match on yo ... (cont.)

Need a vent latch as shown in picture. There is a letter B and a number 5 on one side. There is a PAT #5,553,903 on the other side.

Need replacement that is 2 and a 1/2 inches long by 3/8 inch wide.

Hello, I am in need of both parts circled in the photo I attached. The window is a Traco window from 1998. Please let me know if you have any questions! Thank you!

Is the 26-354-type sash vent stop available in beige?

Hi , I'm looking to replace this part of my vinyl windows ...all cracked or broken Spring action, tilt vinyl window lock. Thank you!

I have a locking screen mechanism that broke and it looks similar to the one listed in this thread except mine does not have an opening. There is however an hole where the broken on is. Would I also use this replacement part as well ( 90-026 One hole sweep lock)? I'm also looking for the window ... (cont.)

Looking for a replacement vent latch. The only numbers on it is the patient # 5,553,903. On a Prism window. Thanks for your help!!

How do I remove the old one and install the new one i just puchased? is there a trick to removing the old one?