Viewing all customer Discussions for:

26-361 Tilt Pivot

Window channel balance, ribbed, measuring 28".

Trying to locate this tilt side mount rod for an aluminum window, goes into a 3/8" balance,

Similar to part 26-361, but the piece on back that protrudes is not in the same position and it looks like it's square and not round.

I am trying to locate this part. The window has no markings on it other than GA on the locks. It is a tilt out window that I am ordering other parts from you for. Is this part availabale? If not is there something universal that I can use?

Please, identify this parts. Thank you.

Greetings ! Please help identify all the part I need. Measurement as shown in the attached photos, I had more but your webapp only allow 5. I think the below is what I need: S600-29 - https://www.swisco.com/29-inch/pd/Series-600-Spiral-Balance/S600-29 15-047 - Pivot Shoe, 5/8" Thick https://w ... (cont.)

I added a pics of: - a window balancer (code 28F bsi be) uninstalled and installed. - sliding plastic slider for double hung window - small metal part that allows window to fall forward (uninstalled and installed)

While trying to put my window back with the new balance I broke the foot off the window. The piece that is attached to the window that slides into the swivel shoe. Do you have these replacements or something that will work with it? I purchased the balance and swivel shoe from your company ... (cont.)

Hello, I need to replace both balances for a tilt in window. It has a hook at the top end as seen in picture 4. I also need a left hand cam pivot(or a set) and both pivot shoes. The balance is stamped 32F, I don't know the brand. The body of the balance is 1/2 wide X 1/2 deep. The channel is 5/ ... (cont.)

We need the left latch when facing the window from inside, brand is GA, and we also need the small lower retainer thats also pictured

Hello, can you identify this metal part that screws into our vinyl window. It sets in the balance pivot lock for a spiral spring. One of ours broke. It is metal. Thank you.

These parts permit window tilting. Tend to be break at the screw mount

The shoe bracket is located on both sides of the window towards the bottom. I work at an apartment complex and these are often found to be broken because the windows won't stay up on their own. I want to make sure I order the correct one, so I've taken two pictures for reference. ... (cont.)

Hi, Do you carry these sash clips that attach to the bottom of the sash and clip into the pivot shoe. I've determined the spiral balancers and pivot shoe I need but can't find this clip. Thanks, Dave

Hello, Would you have a replacement for this part? Thank you

Need help finding replacement for a pivot bar for a tilt window.

Hi, We have 6 GA Windows, white, Single hung, tilt sash needing these parts: 6) each Tilt sash latch, R & L (12 total) top 2 screw holes are 2" center to center. 12) Shoe, for TS Balance, White 12) spiral 3/8" TS Balance, 33"

I am needing assistance with identifying this part, it is the pin that is broken into two pieces. I am needing to replace it.

The balancers are 28 inches long and about 7/16 inches deep and wide. My home was built in 2013 by DR Horton. I also need the part that attaches to the pivot shoe and the window frame pictured below. Thank you for your help with this.

Cant find this type pivot bar. Left side pivot bar is broken