Viewing all customer Discussions for:

23-193 4 Wheel Wardrobe Roller & Bracket

Attaches to top of door, has stanley stamped on corner. No numbers.

We are changing a 2 door 3 panel bifold into 3 door 2 panel bifold. I'd like to leave the existing track. I need to purchase a set wheels and top mounting bracket. The wheels have 4 wheels. The hinges say Acme. The doors were hung 1986 or so. The size of the track is about 1 7/8" wide 1 1/8 high Ph ... (cont.)

Pocket door rollers

Greetings, I have a pocket door located in my kids bathroom. The unit appears to be a pre-fabricated Cox type unit but the previous owners never installed the door. The door opening is 23-1/4" with the jams. Outside width of the track itself, is 1 inch. Do you know what trolley might be a good fit ... (cont.)

I'm looking for a replacement carriage for an interior pocket door. The door was opened forcefully when the carriage was crooked and the whole carriage assembly was bent. There are no markings on the carriage or the track. I've attached photos of the bent carriage to be replaced and the remai ... (cont.)

4 wheel carrier, each side swivels independently 7/8" wheels 1 1/4" distance between wheels center to center (so assume track is also 1 1/4" inside measurement)

It appears that this is the exact hardware a handyman used to hang a door in my house. Problem is, the bolt does not screw in securely to the trolley assembly. Once the door is hung, the bolt slips, the door hits the floor and the system is useless. The bolt thread and assembly thread seem ... (cont.)

Hi, I am looking at your hanger set to repair a pocket door (Product Code: 23-255). The dimension seems to fit the roller I have but I cannot find the size of the wheel.What is the outside diameter of the wheels? I need wheels smaller than 1inch OD. Any chance you have that in stock? Do you sh ... (cont.)

I have a pocket door in my downstairs bathroom that needs the 4 wheel pocket door rollers replaced. Each roller is 3 in long and 1 in wide. Will the product shown above work as the replacements? Product code 23-193

I need 4 sets (2 per door) replacement rollers for my pocket doors. I am assuming the contractor used the least expensive hardware available and they are falling apart. The rollers on my door have two wheels only, are approximately 3/4" between wheels and approximately 1 3/4" from the base to the ... (cont.)

Current Trolley has wheels 7/8 inch, wheel center line .93 inch and length 1.89 inch. Would like to convert to this unit if possible. Thanks Ed

What is the thread specification on the mounting stud? Product code 23-193

I have a pocket door with a wood track. The track has a 3/8th cut out. The wood track width is 1 1/2 in. With the 3/8th cut out and the top track is 1/2 in. Thick. The roller would need to fit on top of the wood track with a bolt drop down through the cut out and connect to the top of door brack. My ... (cont.)

I have a customer looking to replace the part shown in the pictures. I have looked in your catalog and don't see it. Am I missing something? Thanks, Rick

I need to replace several trolleys on some sliding doors. The rubber 'tires' on the wheels have fractured. I have just purchased three replacements from you, but they are the wrong size. The steel body of each trolley is 1 9/16" long and 9/16" wide. Each wheel including 'tire' is 7/8" in diame ... (cont.)