Viewing all customer Discussions for:

82-056 Andersen Lock Bolt Assembly, PS 3 Panel

Looking for a replacement of the latch assembly

Looking for the interlock plates that hold the door snug as it is closed. There's one on each side of the door. It's the plate with 2 screws holding them in place and goes around the locking mechanism.

I just wanted to know if you have the complete lock, frame and weather stripping for this patio door? If so can you please send me the part numbers?

Good Morning, I am looking for a replacement of the attached O ring door lock (just the plate and the middle part) not the lever. Thank you!

Looking for the hardware for my sliding door. See first pic for model info. Thanks!!

The photo is the lock in a what I believe to be an A/W 200 Series Perma-Shield gliding patio door. It was stuck in the locked position. When I disassembled it, I noticed the key cylinder doesn't have any type of 'blade' to turn the lock mechanism. So perhaps it broke off and jammed the lock mechanis ... (cont.)

C1 846 slider C5 848 slider Weather stripping is stapled to door Both doors have same style stripping . I can make cutouts for latches. Other end of door is same continuous weather stripping Anderson discontinued availability many Years ago. Need new stripping, thanks

Missing the mechanism (back of inside door pic) that rotates against the outside door (circular) latch. Looking for replacement parts.

The only hardware I think is salvageable is the thumb latch and the 2 handles. Photo #1 shows weatherstripping I took off the door. There is also a profile of #1. Picture #2 is a stifff plastic with a cut out for the lock. This piece attaches to the outside of the sliding door. There is also a ... (cont.)

Hi I need set of lock and handles and thumb latch. Can you pls provide the quote. Thank you and regards Zafar

After investing time and researh into a viable replacement, company reps had no plausible fix or replacement. Willing to have some alternitive secure (exterior) retro lock assembly. Too exspensive to replace entire 9' full glass enclosure to 3 season room. Your help or advice will be greatly apprec ... (cont.)

Need replacement part for Anderson 3 panel patio slide lock.

I need a replacement for this door here are some pictures of the lock

I'm searching for the 2 parts seen here framing the locking mechanism, not the actual lock. I'm not sure if it's the same part twice (inside and outside) or I'd they are two different parts. Interlock Bracket operating/meeting stile

I need of Locking Mechanism Parts for older Andersen Door - Building Structure built in early 1980's Joe

Door is circa 1986

Looking for weather stripping for Andersen 3 panel 8ft door. P/N PS11-9-OPER

Thought I saw theses on your website. Pls advise Thanks Frank

The thumb latch section works and does not seem to be broken but the key lock part appears to have a broken part on the inside of door so it no longer locks. Which lock would you recommend to replace and would I have to replace the latch portion as well to work with the new key lock? ... (cont.)

Is the lock part we missing I've never seen that lock before so idk where to find it.