Viewing all customer Discussions for:

82-057 Interlock Bracket, Operating/Meeting Stile

Good Morning, I am looking for a replacement of the attached O ring door lock (just the plate and the middle part) not the lever. Thank you!

Missing the mechanism (back of inside door pic) that rotates against the outside door (circular) latch. Looking for replacement parts.

The only hardware I think is salvageable is the thumb latch and the 2 handles. Photo #1 shows weatherstripping I took off the door. There is also a profile of #1. Picture #2 is a stifff plastic with a cut out for the lock. This piece attaches to the outside of the sliding door. There is also a ... (cont.)

After investing time and researh into a viable replacement, company reps had no plausible fix or replacement. Willing to have some alternitive secure (exterior) retro lock assembly. Too exspensive to replace entire 9' full glass enclosure to 3 season room. Your help or advice will be greatly apprec ... (cont.)

Hello, I am looking to replace a weather shield for a 200 Permashield Gliding Patio. Please see attached photos.

I need of Locking Mechanism Parts for older Andersen Door - Building Structure built in early 1980's Joe

Door is circa 1986

The screws will not hold. I have tried plastic plugs. I have also tried super glue. The screws will then hold until the door is closed a few times. I have thought about drilling through the door and putting a bolt through it. Any ideas?

Hi, I'm looking to replace the rusty part on the right. I'm not sure what it's called. Maybe it's called a lock catch or thumb lock receiver or something else.Thanks,David

Need to replace the lock on my sliding door

Looking for weather stripping for Andersen 3 panel 8ft door. P/N PS11-9-OPER

Thought I saw theses on your website. Pls advise Thanks Frank

The thumb latch section works and does not seem to be broken but the key lock part appears to have a broken part on the inside of door so it no longer locks. Which lock would you recommend to replace and would I have to replace the latch portion as well to work with the new key lock? ... (cont.)

Is the lock part we missing I've never seen that lock before so idk where to find it.

Looking for keepers

Could you please confirm that the lock bolt assembly PS 3 panel listed in your catalog #82-056 is a match for the attached pic? I believe my sliding door is Andersen from circa 1989Many thanks Patrick

Wondering if these are installed correctly or need replaced? Our door will not lock at this point. It feels locked but if you pull really hard it will open.

I have Andersen, 82-048, 82-049 and 82-056. Do I need both 82-058 and 82-057 to make my door lock.

Please take a look at these three pictures of my sliding door latch to help identify the parts that I need. Thanks, Mike

Looking for replacement parts for locking mechanismi and brackets surround ing it on Anderson 3 door slider from around 1990 instalation . I see the lock but not the 2 brackets. Need 2 sets.