Viewing all customer Discussions for:

90-263 Face Mount Keeper, 7/8"

This part is a face-mount window keeper

See attached photos and let me know if you carry anything like this -- Thanks. This is for a horizontal sliding vinyl window.

Hello, I am looking to replace this window lock. The only stamp is an outline of the state of Texas MDC 5 written on iot. The keeper is built into the window, as per attached photos, so that wouldn't need replacing. The actual screw hole distance seems to be 2-1/8", but we have replaced some with of ... (cont.)

Both window balances 29DS 38 window latches are broken off missing 9 balance stops

I am looking to replace one of these Cam Locks that were installed in 2019 with 3 Replacement Vinyl Windows. I posted the Cam receiver so you can see what the Cam actually engages with. I have not been able to find anything close with a 2 inch hole spacing. The screw hole set back is 11/16" which se ... (cont.)

MI windows suggested that I reach out to y'all. For mi windows because these parts are no longer manufactured by MI Windows and doors. GA5500 is the window series that is installed in this house. I have one window with missing keeper or receiver. I have sent pics .Thank youEdward ... (cont.)

the spring coils are ok. but need all other parts

I believe the link below is the latch piece I need. I attached two photo's from two windows, one is broken and one is fine. https://www.swisco.com/Keeper-Face-Mount/pd/Hung_Sliding-Replacement-Sweep-Locks_Keepers/90-263 Another question - if the windows won't hold open all the way (some slide down ... (cont.)

Jeld-Wen double hung window lock

Hello, I am looking to replace broken lock, but cannot find the right one. The window is vertical slide Sash about12 years old.

Customer does not have window manufacturer info and needs new locking mechanisms for 6 windows

Replace broken window say lock

Hello I am looking for this keeper and wasn't able to find it anywhere. The sash is a 8100 series. Please help

I was wondering if you have something that might work? If not is there something that is close to those dimensions that I could cut shorter in height and drill new holes?

This latch is on vinyl sliding windows installed in 2003. The double latch plate allows for the window to be locked open 1" in a vent mode. MDC is slightly visible on the underside near the screw hole. A direct match is not necessary, just a latch that will work. Thanks, Bill

Distance from center of hole to center of hole on locking mechanism is 2 and 1/16 inches. Underside of locking mechanism as shown in picture has "2 R". Latch receiver distance from center of hole to center of hole is 1 inch. Trying to replace these part, as some are broken or missing. ... (cont.)

Please see if you are able to supply window lock & keeper or suggest substitute. Thank you

Unit total width 1.5625" unit total height 1" holes 1" ctr-ctr receiving slot .375"h x 1.1875"w need 12 replacement pieces

Attached are photos of the part installed and removed (on 1/10" graph paper). The only marking is a "MDC 5" stamped inside the outline of Texas. The lock screw holes are 2-1/16" apart, like several of your locks, and the lock is 2-13/16" long and 1-5/16" from front to back. The keeper is 2-1/4 ... (cont.)