Viewing all customer Discussions for:

81-244 Sliding Glass Door Roller, Pella

10881 three panel sliding door pella what rollers go on this door

Are these wheels with ball bearings or is it just a wheel spinning around an axle?

2-3/4 long 1-11/16 tall 11/16 wide

I need 2 replacement rollers

Our Pella bottom rollers are sticking and need replacement. Do all Pella doors use the same bottom rollers? Our doors are probably 10yrs old. I would rather not remove the door until I'm ready to perform the install but if I have to in order to determine the specific type of roller we can do that. ... (cont.)

Pella sliding patio doors; sliding portions slide towards each other and lock. fixed panels attached to sliding on each end; four panels in all. Number above from the edge between the 2 glass panels. Rollers appear worn out and door jumps track.Would like to order new rollers.

Hi Tim Hope this helps

I need to replace rollers for sliding door. Please tell me what rollers I need. Thanks

Wheel material: metal Wheel diameter 1.5 inches Housing HxWxL: 1 13/16" x 1 3/16" x 2 3/4"

I have a 1984 Pella Proline series 1299 wood clad sliding door (vinyl on the exterior). Need to replace both rollers. Do you have a part number?

Looking to replace the rollers on my Pella sliding glass door. Length = 2 3/4", height = 1 7/8", depth with flange = 1 1/8", depth without flange = 5/8". Can you help with which roller to order for replacement?

Width:2.75 Height: 1.75 Depth: .75 Wheel: 1.5 All metal Possibly Anderson.

what is the replace part number

Hello, I need to replace the casters on my Pella sliding glass door. My house was built in 2006 and this is the original door. I can see my door has two single wheels casters.

I need a couple of rollers for my patio door. Pictures are included.

I have a set of rollers that look like your 81-098 or 81-244. Unfortunately, in removing them.... the rollers were pretty much destroyed. The dimensions are as follows: Length: 2 3/4" Width: 5/8" Height: 1 15/16" Roller Diam: 1 1/2". The rollers are metal, not nylon. Please advise what I ... (cont.)

Hi, I have a 25 year old Pella door. 96" wide X 80" high. Which is the best roller for this door?

Good Morning, I am going to replace the rollers on my Pella sliding door. I'm not sure which assembly to order. I found number on the bottom of my door that may help to identify the part. The number is Pella-Pel-0108-ASCSFFV1Z2071E080CWHT-525S.

I have part no oc5yoopo sliding patio door that is the roller number

I need to purchase Four rollers and related parts for a older Pella door. Can you determine this by the serial Number IGCC IGMA CIG-2 F 0811.The rollers on it now are the "Flanged Type"Rich