Viewing all customer Discussions for:

39-354 Hope Operator, 4-1/8" HCs

My example has part number L.H. 5565. my mounting holes are 4 1-8" my gear center to pivot arm is about 9. 3/4" I see you may have a suitable replacement part, please confirm. I'm a professional restoration contractor.

FMS co A 90 LScrew spacing is 4 1/8"Approximately 1951Arm is 9.5"

Looking for the swivel knob for these window cranks. See photo of crank with knob, and crank without knob. I need the missing part. The mounting hole is 1/4 inch diameter. Thank you very much.

Late 1950's early 60's casement windows Cranks, current one are brass will take what you've got and need to keep the price as low as possible. This is a project for my church and we will need about 20 of these

I'm trying to locate a replacement crank for a Hope's A 90 R. Arm 4 1/8 screw holes. Arm length is 9.5 inches. I need a left and a right for metal crank out windows.

I purchased the following part from you: 39-344 - Fenestra, Casement Operator, 9". It does not fit because the space between the metal cap and the arm exceeds 5/16". My old casement operator has a 5/16" space between the metal cap and the arm. Based on my research, the correct Fenestra part no. ... (cont.)

18 inch window. I need 2 of these openers.

Awning Operator ID.

I have four windows that had Fenestra 52-01-R/L operators, and they need to be replaced. Do you carry anything that would be suitable?

I have the 9.5 inch length old steel casement operators for which you sell the replacement. It seems the mounting screws are metric? In any event I cannot find replacement screws. In Addition I am looking for the clips to hold the screen as well as the window lock. Any help is appreciated!. ... (cont.)

Any help is appreciated

Hello Swisco Expert(s) - I am seeking to replace worn out casement window operator mechanisms in my house. 1) Casement Window Operators - right and left. 2) Casement Window Operator Handles (see attached pictures). 3) Screw inset into Casement Window Operator Handle that engages with metal spli ... (cont.)

I have a broken crank operator for a casement window. It's marked Hope's and has the numbers 5896 and A901 on it. One part of the screwplate for attaching it is broken off. Is there a replacement part that will work for me? Thank you. I am attaching a photo. Thank you!Suzanne

Need asap if you have it. Must be exactly like the one in the pic

Looking for fenestra casement cranks with screws on the outside

Hello, Any chance you can help me identify this part? Unfortunately my crew was unable to identify the window manufacturer Thanks

Opens left. Arm seems to measure 8" from the bend to the opposite end. Screw holes seem to measure 4-3/4" for the outer holes and 4" for the inner holes. (I'm not great at measuring.) This is to replace a crank on a steel-frame "architectural" (?) window, it has multiple small panes, it's probably f ... (cont.)

I have old metal industrial windows in my house. I am restoring them and would like the fix the cranks if possible. When taking is apart, it appears to be one whole piece. It says hopes Jamestown, ny on it.

I am looking to replace almost all if these operators. I also need the locks and cranks.

One photos the bottom where the operator goes but I don't know what it needs. The other photo is the top of the same window. Thank you!