Viewing all customer Discussions for:

36-018G Torque Shaft Bearing, 5/8"

Looking for a price and availability on this part was wondering if you had it in stock and you can contact me at the below info. Thank you very much

I need a part # for this bracket

Looking for these bushings at the bottom of the window.

Hello,I am looking to replace two broken awning window crank operators and one broken torque shaft bearing. I have attached photos of the (broken) cranks uninstalled as well as the working installed cranks. The only measurement not shown in the pictures is the length from top holes to bottom holes, ... (cont.)

Nylon Torque Bar bearing

Plastic part needed on my jolousie windows, on both sides at the bottom of each window. The 2 holes for mounting are 7/8" center to center. The larger round hole is 1/2" If you have them email me back & I will order a couple. Thank you

Hi This part was removed from a double awning aluminum window with a crank system. The part acts as a pivot for a rod that inserts into the larger hole. The smaller holes are for screws to anchor the part and secure to the window. Can you please help me ID the part and supply it? IMG_8945.jpg ... (cont.)

This part is from a 25 year old PGT 4 pane louvered window. Lower rod retainer. Looking for 16 parts.

This bracket holds the rotating shaft that opens and closes the louver window. I need 16 brackets.

A plastic bracket that holds and houses the bar of the lever mechanism. Circa 1983. Location of bracket is within the window frame, at the bottom, on both sides of the upright section of the frame. Purpose: Holds a bar in place while lever mechanism leverages itself in and out against the stabilize ... (cont.)

Good day! We snapped three bottom roll bars' plastic pieces that lock the windows once we want to close them. Are we able to just purchase the plastic end piece or replace the entire bar? Either way, where can we locate these part(s)? I think these windows are from the 1960's. Your comments wou ... (cont.)

looking for this part for a tempco crank window

Looking for both sides for 6 windows

I am looking for the part pictured below.

The photo Above this sentence this is the right and left side of my window .. The right side somehow got twisted I think when I was putting the pane back in it slipped and I think that?s when It was twisted..... I do not know if you carry them like this or supply only small parts... The next pictu ... (cont.)

I need several of the parts in the photo. They are similar to your torque shaft bearing with product code 36-018G. They measure 7/8 distance between the holes and 5/16 thick but mine is only 1/2" inside diameter.

I'm am looking for a replacement part -please see the broken part which is tour qui bar bearing. Do you have anything that would fit?