Viewing all customer Discussions for:

79-096 Commercial Door Flushbolt, 1/4" Offset, 11" Rod

Here are more photos for you to help me get the part.

Hello- I am looking to purchase the auxiliary door lock assembly for this patio door. Part of the lock/unlock lever cracked off.

Looking for a lever from the back of the operating panel of a Thermal Legance 9500 series patio door that operates mechanism that allows you to have the door slightly in the open position but locked. Any help would be greatly appreciated.

I have a sliding glass door that the handle fell off and also the security lock up above doesn't work either. I have included pictures. Please let me know what replacement parts are needed. Thank youLaura

Hi, not sure if you can help but I'm looking for this part for a sliding glass door. Any help or where to find a replacement is appreciated!

3/4" deep 6.5" Long 1" wide 12" long Rod

Do you have anything equivalent to this. Not sure if it is called a Throw Bolt or not. It is Bronze

Measures 4 inches long x 1-inch width It is the part to lock an impact door. Aluminum, white

Door handle and dead bolt

Do you carry these parts?

Do you have this lock and how hard is it to repair yourself. Thank you Also what is this part called?

These locks (is that the right term) are for securing the secondary doors on sets of French doors. They were from Simonton Doors. The doors are Euro style with continuous hinges. The regular locking and latching hardware on the doors is Fuer brand (Possibly a Multisafe 856 with hook latches), the ha ... (cont.)

I am looking for this flush bolt lever that has broken. It measures 53/8 inches long and 1/14 wide. It's aluminum with a steel rod. Would love to purchase this flush bolt lever or entire mechanism.

I'm not sure how to measure for a replacement flush bolt. I measured from the bottom of the door to the middle of the lock and it measure 18" but I only see two different lengths, the 10" bolt and 12" Any suggestions?

This photo is the bottom of a storm door. The nylon piece shown is what I am looking for. The locking rod is .5 inch diameter. Also, there is a cup/receiver in the floor. The hole in the saddle is approximately .9 (irregular hole). The existing ones are weather beaten.Thank you for your assista ... (cont.)

Active door is a swing bolt that retracts the concealed flush bolt from the threshold. At the same time it retracts the concealed flush bolt from the header on the inactive door. This flush bolt is somewhat bent whereas the swing bolt jams against it rather than underneath to throw the bolt. Thes ... (cont.)

Track door 40-0322

3 of 4 locks are broken. Looking for replacement s.

I think your part number 58-085 will work but wanted to confirm. I have a 2 3/4" door. The channel is 1/2" Can this piece be cut in half for shipment? Also need astragal for the lock area. It measures 7 7/8"