Viewing all customer Discussions for:

58-171 .270 T-Slot Foam Filled Bulb Weatherseal,12ft

Need part number for the attached photos. Thanks

Please see photos. Any help would be greatly appreciated.

I have all 2006/2007 MW double hung vinyl windows across the house I'd like to replace the weatherstripping. The t-bulb is foam filled for the bottom, top and middle of sashes. Then, the rest is a t slot felt.

I have three very normal sized vinyl windows that I need replace the weatherstripping due to dry rotting. Please help me with the best replacement part and could you also please recommend a good spline tool to assist with installation. Thanks, Rich

Weather stripping located at the bottom edge of the window.

Hello, I am trying to identify the correct replacement weather strip along the bottom portion of my vinyl windows. If you could provide some assistance, it would be greatly appreciated. I have 22 windows and they all look the same (need to be replaced). So I would like to order them in longer le ... (cont.)

Want purchase replacement insulation for bottom of my Alliance Window System windows. All the weather stripping on bottom of windows has "came loose" from bottom of windows.Please advise as to where I may purchase such, approx.cost per window and instructions, if any. Thanking you in advance,Steve ... (cont.)

I have 20 year old vinyl single-hung windows without any labels, but most likely American Craftsman. I found the wool weatherstripping for the top and side edges of the window, but the bottom one is so degraded on most of the windows, it's hard to find a reasonable sample to go off of. I did find th ... (cont.)

Can you tell me what product code need to replace the seal in the picture. These are superseal windows installed in year 2004. Thank you very much

I have about 12 windows that need this insulation strip on the bottom of the front sash. Gorell vinyl replacement windows from year 2000.Thank YouTom

Need help with (bubble seal) I order the pile weather stripping 58-099 which is 9/32x5/16 that fit in the Channel because it is 9/16.but the bubble seal I order was 3/16x5/16 that doesn't fit in the channel it is to small can you help me with the Right bubble seal the will fit only one I see that ... (cont.)

Trying to determine the manufacturer to the G-x7166 Window Seals/Weather Stripping shown in picture. Thank you.

There is no number on the vinyl strip there is MDL 1010 on a label on one of the Alliance double hung windows. I hope that this email is bundled with the original email.

Need to replace single hung spiral balance shoe. One shoe is cracked and does not move with window.

I have a sunporch that has 7 North American windows (various sizes). The window seals are in varying stages of decaying. On a couple of windows, the round foam part has come completely off. The seals are on the bottom of the window. Hopefully you are able to see the 3 photos I uploaded. Are you a ... (cont.)

Seal for the bottom of my window. Not sure what would be the best replacement. Thank you.

looking for the offside T-slot part attached in the pictures. Alside double hungs window - SN: 111-705767

I believe the correct part is 58-182 but would like your confirmation. Attached are photos. Thank you,John

This is a 20 year old Alliance Window. Not sure if I need 58-171 or 58-182

I have 5 (five) 40" double hung (double tilt in) windows. We installed them new in late 90's, we think. The bottom sash on one window has a bubble seal on it. As near as I can figure, it is 58-156 for replacement. However, the other 4 windows do not have the side opening where you would slide the pa ... (cont.)