Viewing all customer Discussions for:

26-001 White Sash Release Lever

This latch is 1 5/16" long and 9/16" wide. The two prongs that snap into the window mechanism are 5/16" long and centered below the thumb latch which is also 5/16" long. I ordered some latches from you a couple of years ago but they are too small.

I just purchased White ses window latch and I need the top piece to open it

Length at top is : 1 & 3/16" Width of lever at top is : 9/16" Prongs are : 7/16 inch in length Width of prong at top : 3/8 inch Prongs at bottom are : 1/4 inch

Hi, There is no identification on these windows. The actual slides and internal latches are broken.

Hello, Do you have a part that will replace this tilt latch? It is an internal latch. The piece is 1 5/16 long, has an offset pin that fits down into the hole into the spring mechanism. The piece that hangs down is a smidge over 1/2 inches from the left. The pin is on the back side ... (cont.)

I need to replace this part for my tilt windows. I can't release the top sash to tilt in because this piece is missing. 1 5/16" from end to end Bottom middle tab 4/16"

I don't see any comparable part on your sight.

I am looking for tilt latch levers. 2 inch long 7/8 inch wide

Hello, I sure need you help in identifying the type of latch help needed and instructions replacement, PLEASE.Problem is the latches are there but when sliding either latch button nothing happens (?)Why not?Thank you, Colleen I'm close to your Pennsauken office

We are trying to find the latch that fits in the hole. The window 3 pic is the sideview of the same widow.

I am looking for some of these internal tilt latch operators for one our customers.. Daryl with South Seneca Vinyl

Tilt Lock Info Tilt locks are not on TOP of the sash, they're on the side sash that faces you. The portion that you would move with your fingers is black. The internal parts are white.

Lower sash

But it has a screw under the Lach with a spring behind the screw.

Broken window release for drop down vinyl window

The following in a description of the spiral balance.It has a red tip.It is 5/8" in diameterIt is 18" in length (C600-18?)Weight of sash is 12.4 - 12.6 lbs.2 tilt-latch release buttons are needed. 3/8" x 1.25" whiteThis window is a TILT WINDOW.Your prompt attention to this matter would be greatly a ... (cont.)

We have a home full of Traco windows and several have broken or missing tabs - see pictures. Can you help in finding replacement tabs? Ross Ford

I was tilting my window when this piece fell off. It's the piece that I hold open with my thumbs to release the tilt. Can I just replace this part without replacing the entire latch? Thx!

hi , Iam looking for a tilt latch

I hope the pictures are sufficient. I'm looking to replace the latches that are attached by two screws to the window (underneath the top plastic strip that covers the top of the window. The latches are moved in and out. When they are not pushed in, there is an angled plastic piece that keeps the w ... (cont.)