Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

This part hangs the back of a drawer rail ..... The cabinets are made by Merilat and the hardware associated are branded with a "grass" logo or a G* logo. The cabinets were made in the mid to late 1990s. Thanks in advance for your help finding this part

Looking for part, top left has a "D" cicrlced, top right has a large G with 6 600 below it.

need bracket

Draw slide @23" long

Rear mount for cabinet drawers

It's screwed into the back of the cabinet to support the rail of sliding kitchen drawer. The drawer is probably 20 years old by Yorktowne I believe. The right side is the part that broke (left side pictured), but I would take both left and right if available. There is number on the part 6600 ... (cont.)

This is KCMA A161-1-1990 cabinetry. The plastic bracket at the back broke and there is no support for the drawer. Everything else is still good.

I need to replace a rear bracket for my UNIGRASS 6600 sliding cupboard drawer. Can you tell me what I need, how to get it and how to install, please?

Hi, I need to replace the rear bracket on my sliding cupboard drawer. Can you tell me what bracket I need and how does it install? Any help is greatly appreciated! Thank you. Cindy E.

The plastic bracket for the right side drawer slide in my dresser has cracked. Can you please identify the replacement part and send me a quote for the replacement part?

It is approximately 3 inches long 2 1/2 inches wide at the base 78 opening and 3/8 inch slide guide opening

Need this rear slide bracket for pullout cabinet drawer.

Only marking is that it's made in China

No numbers on it the inside where the drawer guide goes is .970. The length is 1.85 the width is 2.00

Looking for 10 pairs of replacement drawer slides for Blum 513.500.02.05 and 510.500.02.05. They are 2 fixed metal slides with some plastic parts in the slide area. See pix. Just the plastic parts are shot but I will probably need to replace the entire slides if plastic is not available. Plastic pie ... (cont.)

Looking for replacement. Total outside length 4-1/4" . Track Height - 7/8" , Track width - 3/8" . Total inside track length 4" . Track inside length to rail stop 3-1/16" . Back mounting flange height 1-15/16" x 1-1/4" width .

How can I buy this

I'm having trouble identifying the parts shown. I need the rails and the stopper part that attaches to the metal bracket. I'm hoping this picture is clear enough for you all to identify these particular parts.

Looking for replacement bracket for kitchen cabinet pat #4930739 ordered 32-119 and does not work. It is to narrow catches on the bump edge.

Hello! I'm looking for replacements on the brackets shown in the pictures. I'm in need of two sets of left and rights. Thanks!!