Viewing all customer Discussions for:

32-119 Grass Adapter Bracket Pair

I need a replacement for a drawer slide rear bracket. It's for a kitchen island so i can't use a traditional bracket that screws in the back because the screws will protrude from the finish. This particular bracket slides onto a metal frame mounted onto the back of the inside of the cabinet as shown ... (cont.)

Some how the bracket came off and we lost it

This is a Merillat cabinet from the early 90.This drawer dive at the rear.When trying to place the piece of IMG1658, it is too short for holding. I noticed a bent at the back end of this piece. Is that the reason. What should I buy for replacement?

This is the part that is still in the cabinet. There is another part that is broken. (I do not know how to add a second picture). Do you have a part for repairing this failure? The cabinet was installed in my kitchen in 1990 and the drawer that failed is the one that has my silverware in it. If ... (cont.)

This piece broke. Can you help me find one?

Brackets are located between draw slates and with out 6600 old rear supports I would have to take cabinets apart. The slide on the back would make it easy to replace. Your friend, hard to reach....

Having difficulty finding this part.

We have a total of 6 drawers. The pieces we need are 2 1/4 " each. The cabinets were made by Scheirich. My parents are elderly and I am visiting for a short time. I need to get these fixed before I leave. Any help in getting these would be much appreciated.

This plastic bracket is broken on two of my kitchen cabinets, causing the drawers to fall of the tracks and downward. I'd like to replace these before reinstalling a new brackets style. The plastic piece snaps into this black bracket behind the back of the drawer.

I need both sides times 2 for the end supports for the pictured rail. Rail has KV and a smaller CR stamped on it.

Late 80's cabinets have these plastic pieces that sliding drawer tracks go into. They are starting to break. Do you have replacement pieces? Got the broken piece(s) out, 301515 is the number stamped on the plastic piece.

I saw similar on posts but the replacement doesn't look like it would work. As you can see on the inside of the cabinet the back has a piece of wood to help support the bracket. disappointed that I can't find metal replacements....doesn't seem plastic is very strong.......

Two of the brackets from my kitchen drawers are broken. I would like to replace the brackets. Do you still have this bracket? If so what do I need to order?

looking for this exact replacement or something that would be a good replacement.

Hi. Purchased these, but they didn't hold the weight of our kitchen drawer for very long. Do you have other options that are of the same size, but sturdier or where the part is one piece instead of one part that fits into another part? Part #32-012 comes in 2 parts. Thank you for any sugg ... (cont.)

trying to find replacement back bracket that is 2 1/4 x 1 1/4 and appears a quick snap which has a metal bracket this slips into. The metal part says grasso.

I'm looking for the replacement to this drawer slide. It appears it has two plastic dowels. Haven't seen it before.

Plastic bracket at back of drawer hardware to hold slider in place. Existing piece has a large G with the numbers 6020 6 and either RH or LH after the number. We have located similar items but they are not large enough for the drawer hardware. Need opening approximately 1 inch by 3/8 inches. Th ... (cont.)

Do you have this item

Looks to be Nylon, mine is broken. Large letter L on upper left hand attachment plate, apparently to identify left side. Smaller letter D in extreme upper left corner. On the right side of the plate, large letter G with an asterisk above it on its left. 6600 written below the G. Large letter G pri ... (cont.)