Viewing all customer Discussions for:

33-087 8-32 x 3/8" Phillips Truss MS Zinc

Red these parts. If you don't have the bracket then the rollers/wheels would probably be fine as well

Need to find replacement rollers. These seem to be worn allowing the drawers to drag. They are part of a Knapp & Vogt slides made in Grand Rapids Mich They are about 7/8 inches

Hi ,I am looking to replace a Stanley Dial closet Roller. I recently tried one from National Hardware (V-795) but it didn't work . The wheel is to close to the track.The ones I am trying to replace have a .125 shoulder. Wheel diameter is.84 .Offset is 7/16. I have attached photos. Both doors had th ... (cont.)

Scheirich kitchen cabinets from the 1970s. Looking for replacement hinges. Cabinet frame is 1/2" thick. Door overlay is 1/4". Also looking for roller assembly brackets for the drawers - US Patent No. 3,980,364. Thanks.

The slide in the picture is from a Wood-Mode kitchen cabinet. 22" slide Roller style is round, with is 1/4", diameter is 7/8" ( The worn rollers are ball bearing type) Looks similar to your 10-101 roller?

I need two sets of these roller brackets

I have been trying to find these high quality shower door rollers. They have nice rubber around it and ball bearings. I have found plastic replacements but they are not as good. The rubber helps for smoother glide. They are 7/8 inch in diameter. Any suggestions?

The glide is 16 inches long and the roller is about 7/8 of an inch. It says GRANT 338 on it.

Wondering if you have a roller like this? See attached. It is for a sliding glass door.

I have two pictures of the parts I am looking for or a replacement that will work. The corner clips are a clear plastic with rollers offset

I will require about 10 of these screws which appear to be 3/8 of an inch long and 5/16 in thread diameter. The white nylon guide bushing appears to be 7/8 inch diameter or so and I will need four of those.

This appears to be a Grant track system. I can see in tiny letters, Grant 23_, the third number is a 6 or 0 maybe (hard to tell). The track itself seems fine, but the rollers on the right side have fallen off the drawer and the cabinet track. The left side is about to go too! The rollers look as if ... (cont.)

I am looking for replacement part for the following. Can you help me?

LOOKING FOR THESE, 3/4 IN DIAMETER

I need a replacement roller. It is 1" oval as shown in the pictures. I do not have shower door model number. But the glass is stamped. 16cfr120116cfr1201-II, ansi z97.1-2004, 5/16ua sgcc 3961.

This is a nylon wheel with ball bearing center to a clinic sliding door on the counter. It is threaded on the inside of the bearing, the screw holds it on the track. The one photo (0663) of the width of the wheel shows that one side of the wheel acts as a spacer. That is the side that is against the ... (cont.)

We are trying to repair our closet door. Do you have this part?Thank youPam

Hello, my drawer slides are made by GRANT. The photo has details of one that is intact and the other that is missing. The slides are circa 1978-81. Can you help identify what part I need to order? Thank you.

I need some replacement rollers for Steelcase desk..I think I was in touch a few years ago..you guys are in camden? I would like to purchase 10 large 10 small 10 retainers buttons

Need new ones for sure