Viewing all customer Discussions for:

90-278 Lock & Keeper, 2-1/16"

Sliding window latch. Do not see any model numbers etc on window. They may be from a company called Silver Line

It states certainteed. Lock is on the left side with a arrow/triangle above it. Number 45183 underneath and then an 8 underneath in a separate area.

Please advise part to replace the latch.

Hi, So I looked at/measured the existing keepers (length/screw holes), then looked through your website and found what I though was a match; then proceeded to order 12 of them (order #1557151). However, when I installed one of them I discovered the ones I ordered are too deep (bottom window can't sl ... (cont.)

I think this swing lock set will fit dimensionally. The ones we have at present are really cheap plastic. Are your replacements made of metal? I only want to replace these once!

Can I please order the replacement latch's that look like this.Thanks Frank A.

Looking for these specific parts! I am in need to replace parts for a total of 9 windows. Looking for 18 total latches and 16 total locks. The latches measurement is 2 5/8 inches width 3/8 inches in height 5/8 inches in depth The lock measurements are 2 3/4 inches in width 1 1/8 inches in depth T ... (cont.)

Lock latch for window. House built in 2015 by Ashton woods in lake Mary, Florida.

I am looking for this kind of window lock. The brand is Viking. I looked everywhere and I can't seem to find anywhere. I was wondering if you have them? I need a 3 pack if that's possible. Thank you.

Hole spacing is 2 1/16 , hole location from front is about 11/16"

Part says 9311 A-S PA with a B at the bottom of the lock. Measurements between the holes I believe is 2 1/8 and from the hole to the back of the lock measures 11/16.

This latch is off of a double hung wood window. Window brand name Portrait Made by Carolina Builders Lumber Yard AKA Stock Building Supply You can see the number 8300-02 body Any help appreciated Thank You

Window latch for a silverline window.

I have ordered a few versions but never seem to quite get it right. Vinyl double pane windows from 2015. I believe they are a window made by Anderson

First I really need the flip latch. I d also like the lock and the small plastic tab that keeps windo from opening. All pictures attached. Thank you

These locks are on windows approximately 8 years old. Tan in color.

Looking for a replacement for this guy. The windows have two latches, this one locks to the right, the other locks to the left. There is an L imprinted on the latch mechanism. I believe it's 2 1/16" hole to hole and 11/16" backset

I believe Alcoa is the manufacturer. The windows were installed in 2013. It's 1"x 2 3/4". Stamps on inside of latch: AN 8300-02 8301-1 8313 002

This latch is on vinyl sliding windows installed in 2003. The double latch plate allows for the window to be locked open 1" in a vent mode. MDC is slightly visible on the underside near the screw hole. A direct match is not necessary, just a latch that will work. Thanks, Bill

I bought item # 90-300 face mount keeper and sash lock for double hung vinyl windows that were on house when I bought it 3 yrs ago. The face mount keeper that came with lock is too long which means it sets up too high to catch locking mechanism. I need a keeper that is 1 inch high with holes that ar ... (cont.)