Viewing all customer Discussions for:

90-278 Lock & Keeper, 2-1/16"

Hi, I would like to get replacement part for the attached picture. Not sure which one it is on your website. Please let me know what item I need to order. Thanks

Just going to assume you can get these photos. If not, let me know and I will try another avenue. Built our house May of 2014. These windows were installed in the new build. Silver Line double hung - tilt out for washing with plastic closers on the top. They sometimes last for four or five uses ... (cont.)

Viking sask lock 8300.02 measures between screw holes 2" by width 15/16"

Hi! I actually ordered about 20 of these from you last year some time. I think they are 2 and 1/16 inch holes. (I think). I just need two more! Any chance you can check your data base to see what I ordered last year? Jared

Do you have a replacement latch that will fit Viking windows? I would like to replace the older latches on Viking windows (lever type) with new sliding latches like the Jeld-Wen sliding window latches. Thanks Michael

I have several silverline windows (circa 2005) pivots, tilt locks, pivot bars and channel balances need replacement.

Do you have a replacement for this combo?

I inherited a house, the windows are double pane, probably 10-15 years old i would say. During the last hurricane, living in Daytona Beach, a window blew out and broke, i had the glass replaced, and did not realize that the lock and sash were broke as well. I have searched high and low to find the ... (cont.)

Hi, I am looking to buy replacement locks for my double pane sliding windows (Viking brand). From one of my images, you can find the model of my windows. Would you please let me know if you do have something similar to what I am looking for. Thank you very much.

Hi, I am trying to find the hardware latch for my window. I don't know the brand name of the window. Do you sell the hardware latch? Thanks David

I need to replace some of my window locks. The windows are slipping from the top, which causes an opening at the top of the window - allowing air to come in.

KEEPER DIMENSIONS: Center-set: 2-1/16", Width: 1/4". Overall length: 2-9/16". LATCH DIMENSIONS: Center-set: 2-27/32", Backset: 21/32", Overall length: 2-9/16".

I have three windows that the locking hardware is broken. I need the window locks that have ACAN logo on them and the hardware locks that allow the window to be tilted in for cleaning. I have not been able to find any other information on the windows. Please refer to the attached photos to help id ... (cont.)

Hope you find pictures and measurements helpful. Thank you, Chris

Hi, Looking to replace the broken sash lock on my vinyl double-hung window - not sure of the manufacturer but I've included a photo of the label that's on the window that might help, along with photos of the lock. Any help would be much appreciated!

Please review the photos attached and advise

Hi, I hope you can help me purchase two of these. They are from about 1994 and go on a vinal 36" high x 5' long window in the center. It is the only lock. the thin piece has to fit into a groove in the fixed portion of the window and lay flat. The piece that is missing(the handle) has to be very s ... (cont.)

I need replacement for a missing lock on my window. I think someone else mentioned the 90-278, which might fit.

I have a broken slider latch from a roughly 15-year-old Viking window (purchased from Lowes). The closest match I could find on your site is 90-278. It mounted correctly, but doesn't latch properly. The old striker lays flat against the window with screws perpendicular to the latch. The old disc i ... (cont.)

I need to purchase a replacement window latch. See attached picture. Please send me the part number to reorder. Thank you, Laura