Viewing all customer Discussions for:

26-129 Pivot bar, Slocomb

4 inch total length. 1/4" depth

I think this is called the sash pivot bar. I need two please.

Hi, it looks like a r-nose pivot bar but the dimension are not the same as what you have available on your site. Have you seen anything like this before? Thanks, Steve

Looking for a part to match

need 4 pivot pins for bottom to hold up my tilt in windows.

I need replacement pivot arm and spring please tell me how much and if you have in stock and how I can get them sent to me thank you

For a Window what keeps the windows on track

My window was not staying up, and I found that it was a broken tilt pin that was the problem. But when I search tilt pins online, I can't find this specific one. It's 4 inches by 0.5 inches.

Pivot bar has 3/8" wide foot, with two holes approx 13/16" apart. Bar is 4" long, but only the foot and the first hole are needed to install in my window.

Balance pivot pint for a Tilting double hung from Vinyl Tech in Poughkeepsie, NY (now permanently closed). Cannot find one anywhere?

Held in place with a single screw through the sash. Sash is already in hands of glass replacement guy but the only thing that shows is the short tab and of this pivot bar

Hello,Take a look at our expert's recommendations to customers with the same hardware here. Your pivot shoe is no longer being made but our 15-175 or 15-177 could be used as a replacement, which are both used with the S152 coil springs. As for your pivot bar, start by comparing the dimensions and of ... (cont.)

In the picture you'll see the old parts of the window the pig barn is broke with the oh shoe I Purchased a new pivot bar and shoe they're not compatible and don't work I need help finding the correct part

Hello, I am looking for this vinyl window pivot bar. Are you able to supply this to me? I am looking for 15 to 40 of these. It depends on the price.You would be shipping to San Francisco, California 94109.

Hi,I?m looking for a pivot bar (see photos). It's simlar to the 26-396 T-NOSE PIVOT BAR, 3-1/8", without the "Tnose" and is 1/8" shorter. I have three broken and will need to order 14-16. Better to replace them all now than one at a time. Please help.Thank you.Leo

Thanks for your help with my problem.The pivot bar #26-129 (third picture) is correct. The pivot shoe #15-152 (first picture on right) is incorrect, the one on the left is the one I am trying to replace. Size is good except 17/32 thick would be best. The second picture is the old one, note the recei ... (cont.)

I'm trying to figure out the manufacturer of this window and I need a replacement part that fits into the side sash because the other side is broken.

Similar to your 26-129 but not quite the same. Overall length: 3 3/4 inch. Main body: 11/16 x 1 19/32 . Nose: 1/4 x 3/8. Tail: 1/4 x 1 25/32. Thickness: 7/32. No brand or number on pivot bar. Aluminum frame of sealed glass stamped as ALWCO-84. Same vinyl pieces inside the four corners of vinyl w ... (cont.)

Hello our windows are not marked anywhere for reference but we are in need of replacement parts, pivot bar, shoe and perhaps the spiral balance spring. Thank you in advance for any assistance you can provide.

It's the pivot bar from the bottom sash of a double-pane, tiltable vinyl window. It has no numbers or other markings whatsoever. It looks very close, but not identical, to the one you list as 26-129. My biggest worry about 26-129 is that it's 3/8" thick, whereas this one is only 1/4". If you l ... (cont.)