Viewing all customer Discussions for:

90-283 Face Mount Keeper, 1"

replacement window need 4 pcs, don,t know who made

my single hung Patriot brand window will not lock. the lock does not line up with the keeper and need to know if you sell a taller keeper or a fix / work around to lock this window. I am assuming the window is out of alignment due to 13 years of closing the window without locking it. ... (cont.)

This latch is on vinyl sliding windows installed in 2003. The double latch plate allows for the window to be locked open 1" in a vent mode. MDC is slightly visible on the underside near the screw hole. A direct match is not necessary, just a latch that will work. Thanks, Bill

Keeper 1" hole center, Dimensions 1-1/2" wide by 1-3/4" tall. Marking 026-4 on back Lock 1-1/16" hole center by 7/8", Dimensions 2-1/8" wide by 1" deep, Sweep projection 1/4"

We need 2 sets of 27 3/4" balancers 4 sets of 33 3/4" balancers 6 bottom pins 1 window latch Please see attached photos

Width is 2 inches Height 1 13/16 Holes are 1 inch apart I believe keeper is from Champion windows. Insulated sliding windows on 3 season room built in 90's

I have windows and need to replace the keepers i did order keeper but they are wrong size and returning them the ones i ordered were item #90-257

Trying to find this piece.

The lock on the right of the picture is broken. I need this part for a few of my windows.

White approx. 2.75" long with keeper that has two slots

Hello my name is Chad and I work at an apartment complex which has what I believe windows manufactured by MI? The identification sticker is MTL-4. We are finding it very difficult to find these sash locks. Any information would be greatly appreciated.Thank you.Chad

Hi the brand of window is trim roll . The window lock doesn't work. I need to replace this exact part.

Hello, I am reaching to you in hopes you are able to help me with the broken window latch. The only markings I was able to find are XA-S 9052. As you can see from the attached pics what is broken is the little bar across which I guess prevents the window from being open once locked. Any help would b ... (cont.)

i bought the 90-041 and 90-042. The grab rail thing on the sweep sits twoo high to engage the keeper. It hits the keeper and won't lock the window. All of the other holes match. The windows are old so I can't drill new holes. I just want the keeper to be a little higher.

Do you have sweep locks for my sliding window?

Looking for the sash keeper in the picture. Screw holes at bottom are 1 inch apart. Height is 1 3/4 inches. Thanks

I need a couple of replacement keepers for an Okna window manufactured in 2007. I attached a photo. The screws are 1 inch apart and the entire keeper is 1 1/2 wide by about 1 5/8 high. It is

I'm looking for the part that the lock goes into to lock. If not sold separately the whole lock Assembly.

Trying to find something that will work to replace these old window locks - windows are sliding windows

I can only see letters EPI on it