Viewing all customer Discussions for:

21-286 Snugger

The plastic guide that fits in the rail, that the door peg sticks into, has broken. I can't find where to get a replacement. I'm not sure the age of the door or the manufacturer. The label is partly covered (see photo). Do you know if the part is still available anywhere? Thanks. ... (cont.)

Tim, Here is a picture of the hardware, the house went thru a flood. The doors are still in good shape, but when they tore out the floors & walls the threw out the tracks. Pat Sequin Lumber

Dear Paul: In these bifold mirror doors, I'm missing several parts. The sticker on the back says Arch Mirror and the track measures 1 3/16 " X 3/4" measured outside.Please advise if you carry the parts like pivot bracket, roll guide, corner connector, pivot pin, screw driver bottom pivot that would ... (cont.)

We have a mirror door with a closure to hold the door flush when closed. It appears that this part needs to be tightened as the door is not closing flush. It appears to be a circular wire and it is held together by a rivet so there is no tightening a screw. Is there a replacement for this part? ... (cont.)

I am looking for replacement parts for a Stanley Mirrored bi-fold closet door. I need the floor channel and the four roller assemblies that fit in the corners of the inside of the doors. Channel is 24 inches long, 1 inch high and 1 inch wide. Roller assemblies have the number 4405-R . Please h ... (cont.)

I'm not sure if Part# 21-286 is the part I need? I have older Stanley Mirror Bifold doors. In the 1st image the red print Number is 50502962 243554 The part sits in the middle of the Upper & Lower track. Has a spring in the middle of the clip to keep the doors snugg when closed. Thank you Joe ... (cont.)

Stanley bifold mirror doors these are the hinges in the middle of doors that it opens and closes with.

I bought a 36" x 80" Gardner bifold mirror door for my closet around 2011. The track pins-parts (as shown in the photo) have broken. Hinge side is fine. Bifold center pivots are fine. But the outer pins on both the upper and lower have left the nylon guide wheels and just won't stay in place if I tr ... (cont.)

I purchased these mirror bifold doors from Lowes and we are missing parts. We need the roll guide and snugger shown in these photos. Could you please let me know if you carry these replacements? I will include a link to the product I purchased. Thanks so much!!

21-455 has how many rollers and end guides. Will it hang two doors or do need to buy extra set of rollers and end supports? Thanks, Peter

I am looking to replace the bottom track of Stanley Monarch sliding glass doors 50822981 / 64564-001. I also need the rubber rollers for the top track guides. Can you assist? Thank you