Viewing all customer Discussions for:

10-325 30" Shower Sweep With Drip Rail

Recently water started coming out from under the shower door. I'm looking to replace the vinyl sweep. If that does not work, I think I might have to replace the aluminum channel. Do you carry these replacement parts. Note that there are two screws on either side of the channel.

This gasket sweep slides into a t shaped channel but I cannot find the right size anywhere. The door is 24" and from the early 1980s. Advise? Thanks.

I wanted to replace our drip rail which was attached with 4 screws, and had a vinyl sweep underneath. However, it measure as 27". Can this be correct? Which of yours would I purchase or do I need to keep looking? I think I can reuse the aluminum drip rail again, but would still need the vinyl sw ... (cont.)

Need a replacement for old (25 year old installed) Basco shower door sweep. Hope you can assist me, you're my last hope. Thanks. Tom

Shower sweep

The gap between the bottom of my shower door and shower threshold is 7/8". Will the Shower Sweep With Drip Rail work in my shower? Is it too big a gap? Conversely, if the sweep is too long, can I cut it?

I am looking for a Gold Shower Door replacement rail that can hold a vinyl sweep. It can be plastic or metal - as long as it is looks like gold or brass. Thank you. Larry

Shower door sweep sweep is ripping and needs to be released

This is attached to the door with double side tape. The vinyl on the bottom is partially missing. The vinyl extends 1/2 inch down. What do you have for replacement? Your 10-325 looks close. thanks

Looking to replace drip rail/gutter on Lasco, or Lascoat, or Holcam. Have found all three names. Model seems to be Lasco SL-4. Parts described as V-11 Vinyl Gutter and VR-23 Gutter Plug.

My current framed shower door drip rail is 24 inches at the shorter end (closest to shower door glass) but about 25.5 inches at the longer end as 1.5in overhangs. Will your 24-inch sweep with drip rail work in this configuration?

Hello, I am looking for a seal for the bottom of my shower door (see attached pictures). Thank you! Fred

Our shower door was custom made. I'm not sure how many pieces the sweep has & if it was glued into place. The sweeps I see for sale do not have a rubber bottom like you see hanging off of ours. It turned black very shortly after installation. I have tried to clean it with many things including t ... (cont.)

Need replacement parts and screws for framed shower door. 21 1/2 inches long and Drew's are 2"" from each end

I'm looking for a replacement sweep for my framed shower door. I included 2 pictures.

This part is from shower lower door for blocking water. It is damaged and the water is leaking outside the shower.

Hi, my shower door sweep came off and is mast so I figured I would just replace it. The piece I have is about 26 1/8 inches and the holes are are about 24 3/4 inches apart. I saw y'all have a 24" and a 30". 10-325 is the item I was looking at. Would that work for my door you think and what size? (I' ... (cont.)

Clear vinyl. Upper section (circular with four 'fins') presses into aluminum channel in bottom section of door frame.

I have a framed shower door and needing a replacement door sweep with no luck. I measured and the sweep is 3/16" x 13/16" I think if I'm reading the ruler right.

I have a very old framed shower door and need to replace the sweep. The actual sweep holder is okay. I just need the rubber (perhaps now vinyl) sweep insert. Thoughts? Many thanks.