Viewing all customer Discussions for:

32-006 Soft Close Adapter

Hello, I have a pair of top lift cabinets, one of which no longer closes softly but rather slams shut. I took the hinges down and realized the pistons that slowly lower the cabinet face no longer produce any resistance. The only marking on them is "0809-2 T-K-3". I've searched through the Blum websi ... (cont.)

Can I get a soft close/dampening attachment for what I think is a 32-345 (Wrap Around Frame Cabinet Compact Hinge) See picture to confirm hinge type/model #. If not, do you sell separate soft closers/dampeners? If what is the model number/ link? Thanks.

I need 6 soft close dampers. Photo attached. Gray damper part is about 3.25 inches in length.

My under mount pullout slides are slamming closed and I'm looking to replace them with same slides. Any help would be appreciated. Thank you,Ron

Are these soft close? 32-345

Hello- I have Wellborn cabinets installed in my condo that I rent out to vacationers. The cabinets are from 1993 when condo was built. Pictured are the current hinges. I want to upgrade to your soft close hinges and plan on installing new doors. Which hinge do you recommend? Thank you, -Jerry ... (cont.)

Need replacement hinges for this ONUS hinge. I understand from other communications that you don't carry ONUS hinges. If you have a suggestion, would you please send dimensions for hinge and hole placements as I don't feel comfortable doing this myself unless the replacements are exact fits. Also, ... (cont.)

I need to replace several of these small soft close pneumatic tubes. They have a small magnet on the tip. On the end opposite the magnet is the letter G with an *. It also says made in EU. The cabinets this comes with are branded "Quality" cabinets.

It is inside cabinet behind the drawer. It's about 3in tall. I operates along the same principles as the magnetic pop-up door closer/catch. When you push the drawer in it loads it then when you push the drawer again it pops out and pushes the drawer open enough to grab it and open it, but you alread ... (cont.)

Hello - I dropped a heavy item on the drawer and bent the face frame undermount brackets of the drawer. The drawer undermount slide is 19 3/4" and the bracket that attaches to the back cabinet is 23 1/8". Do you have replacement brackets and back wall mount? Saw an answer on your website that sai ... (cont.)

Piston has magnet and snaps in. Latch has flex plastic for spring and holds slide out to front edge of drawer

Can the slow close adapter be used on inset style cabinetry?

What is the overall length of this adapter, and what size drill is needed if I want to install just the tube shaped adapter directly into a shelf face?

I'm missing one of the front door guides and one of the black skinny pieces that looks like a piston. I've pointed to both on the photos. These are for a bathroom vanity drawer. I cannot find any manufacturer markings on the parts. Thank you!Anne

I'm looking for the air dampener part for the Grass Elite Plus 19 undermount slide. The slide part number is 7523-19/550/533, the dampener has "28.02.07 AVS421 1L08C04" on it, but I can't find it anywhere. Thanks!

We have Thomasville cabinets & the draws dont fully close. Can we purchase new draw softeners. Looks likea plastic clip with a piston.Thanks,Bill

Do the 32 335 hinges have soft close, or is a damper available? I am using these on steel cabinet doors where the 35mm bore is not possible. Thanks!

where is the best position to mount soft closer? hinge side, handle side, top board?

Is there an adjustment screw to vary the closing mechanism or is that not needed?

I was looking on your website and it appears that you have a hinge that matches up with an old hinge I have (#3391420). I