Viewing all customer Discussions for:

33-104 Phillips 1/4-20 x 3/4" SS Machine Screw

Looking for replacements for 2 rollers

Need to identify and purchase two single rollers for my sliding glass door. The dimensions and diameter of the wheel is 2 3/8' L x 1 3/16' high and 9/16" Wide as shown on uploaded picture with a 1 1/8" wheel diameter. PLease advise.

2 each: Roller hardware 5/8 wide 2 inch long 1 3/4 tall with 2 inch roller wheel.

I removed bottom rail of door to get to rollers, The wheel housing is approx. 2 5/8" length, 1" height, 11/16' width. The wheel was sitting approx, 1 1/4" above the housing. The wheel is approx. 1/4" wide. The wheel had the following words - Killian Toronto and Syracuse N.Y. If possible, I would li ... (cont.)

This aluminum sliding door has no name printed on it but has a nice wood handle on the interior. The roller housing is enclosed in the bottom rail that accomodates up to a 3/4" wide roller. Because the roller assembly contains some rust because of previous water damage my measurements are best estim ... (cont.)

Several days ago we called about roller replacements. Here are the photos of the rollers.The first photo shows the lower frame which supports the glass and holds the rollers with a screw securing the roller assembly to the frame.The second photo shows the approximate dimensions of the roller assembl ... (cont.)

I need a roller and housing for my sliding glass door. I saw another person with the same roller as mine from a 2013 post on here. I hope you can find one for me. I hate to scrap out a perfectly good door just because I can't find the roller. Unlike the 2013 post, the measurement on the housing is n ... (cont.)

Outer stamped metal is 1 3/4" tall, 1 15/16" long, notch at bottom is 1/16". Inner stamped metal is 1 11/16" tall, 2 1/16" long. Outer bracket is 3/4" wide before it slims down to squeeze inner bracket. Inner bracket is 1/2" wide. Wheel is 1 1/4" diameter.

No identifying letters or numbers on the roller.

I am looking for this part to secure my storm door glass.

I need to replace the rollers on my patio door. Unfortunately, I can't find any product identifiers on the door or the rollers besides, Fasco printed on the side of the roller. The height of the rectangular housing is 1" The width seems to be 11/16" The length is 3-1/16" The wheel diameter is 1 1 ... (cont.)

Looking for replacement roller assembly for older trimview sliding glass doorRoller Only, 1-1/2 Diameter Steel Wheel 1/2" wide 1/4" hole

I need screws too

I need to know the size of the 2 screws and nutx

I'm looking for a replacement sliding glass door roller pulled from an unbranded door Engraved "MBC 1116"

I need an entire roller for a sliding glass good. It's an older door and am not able to find parts locally . I need two in order to balance the sliding glass door

Any idea? Thanks

Hello, please help us identify this roller and if you have it available for sale

Hi,I'm trying to find a set of replacement rollers referenced in the subject line. The house was built in 1957, and the doors may be original to that year. They are just a friction fit in each end of the frame with a height adjustment screw positiooned vertically from the bottom.I've attached a few ... (cont.)

11/16 wide by 1 inch tall by 4 1/4 long. Wheel is 17/16, or 1 inch plus a 1/16th. The hole on top is 1 1/2 inch in center of hole to end. There are no numbers or markings.