Viewing all customer Discussions for:

33-104 Phillips 1/4-20 x 3/4" SS Machine Screw

This is not your typical roller and I need to know what this part is called or where to find a replacement. The door does not have a manufacturer tag on it.

I have an old Daryl patiorama 200 sliding glass door. Where can I find roller replacements? Thanks, Paul

Looking for replacement assembly. Only one of the two rollers is bad - a ball bearing came out - but might as well replace both.

I could not find any numbers on rollers or on the door itself. The door is in a Manufactured home built in 1993. The measurements I took are as follows: 15/16 thick, 2 9/16 long and 1 3/8 tall.

Stamped on one side A-S. 7837 Nyc Looking for 2 sets Thanks. Jack

I am looking for sliding doors replacement wheels. Thanks

I'm looking to replace this roller on three sliding glass doors, and I'm wanting to get a new roller with nylon wheels. As of now its metal on metal (metal wheels on metal track) and they cause some noise. I'd like to replace them with nylon to quiet/lessen the noise. Do you carry a roller that matc ... (cont.)

Hi, I believe these are the inside pieces and the door was put back on, so I can't get the housing out. I just have to try to do the best I can with it if you can help recommend a product. Piece is 2-1/4" length, 1-5/16 high, 7/16 width. Roller is approx 1-7/16 (assuming 1-1/2") Than ... (cont.)

Sliding door roller replacment

This is my roller assembly, I require 2-each. Also there is a felt pad in the bottom track I would like to replace.

I purchased your 81-158 tandem roller. My old screws don't fit. What is the correct replacement screw thread count.

What size screw do I use for 81-261?

This is out of a 31 year old slider made by Trimslide, who are out of business. Can you match this up for me? Thanks, Paul

HELP! I am trying to replace the roller's in a sliding glass door in my home, the house was built in 1984 in south Florida and it is a 8ft wide, 74" tall door with a metal frame. The pictures attached are the roller that I was able to pull from the bottom of the door. Here are the measurement ... (cont.)

2 1/4" wide X 1 1/4" tall X 7/16" thick No part numbers. Two rollers per door. Ray Door manufactured by James Ray Company of Wichita, Kansas. Firm no longer in business. Thanks, Michael