Viewing all customer Discussions for:

58-186 48" Duo-durometer Door Bottom Sweep

Hi there! I recently moved into an older house (built in 1935). I have been looking everywhere for a replacement door bottom, but haven't had ANY luck. (see attached photo) A fellow at Home Depot told me this was an older "stanley type" door bottom. Thanks for any help you can provide in identif ... (cont.)

Hello, Can you please tell me if you have a replacement door bottom as shown in the attached photos for a steel residential door? Thank you.

Hello, house was built in 1992. Prior weatherstripping has a t-strip attaching weatherstripping to door. Can't find anything like it at local retailers. Can you assist?Thank you!Julie

I have a Lincoln wood door with t-slot weather stripping that slides into the drip edge. The top of the T is 0.1875 inches. The weather stripping has becomes ripped and damaged and needs to be replaced. I would like to know which one would best fit my door. Pictures attached. Thank you! ... (cont.)

Looking for the door weather strip shown in the picture and in the rough diagram. Do you have anything like it? Ship toCanada? Door is 1 3/4 inches thick. Thanks, Bob

Replacement for a sash on the bottom of a metal door

I am looking for a rubber seal to my front door. I need the part where my finger is pointing in the picture I uploaded. It is a rubber seal for the front door. Right now my rubber seal has disintegrated leaving a hole between my door opening.

Trying to find a replacement door bottom. Attached pic...door bottom with no numbers or markings on door, vintage 1987. Outside total width is 1 3/4"; overall height is 9/16" on left side of pic and 1/2" on right side of the pic.

I'm looking for the replacement rubber that slides in the 2 runners Name of product or part # or where can I purchas

Hello, I had a new garage door (door going from inside home into garage) installed recently. When the wife and I removed it to have it painted, we noticed the metal bracket at the bottom did not have a seal (see pic). Wanted to see if ya'll could help us figure out what seal to use here. Thanks! ... (cont.)

Looking for a replacement sweep haven't been able to find the exact one so far...need help

Hello,I am looking for pieces of weatherstripping with this profile, can you help me with this?Courtney

I have a 72X80 stanley steel double entry door Model 251271. I need one sweep for the door bottom. Plus I either need the wooden part of the threshold or the entire 72" long threshold assembly. Are these parts available? Thank You David

Looking for the door sweep, top and sides weather-stripping for patio door. Can pay to expedite if possible

I have this door t-slot bulb bubble seal that has a width at the t-slot of 1/4" and the bulb circumference of about 1/2".8 cannot find it anywhere.

Looking to identify this door bottom weather striping so I can get a replacement insert. Any ideas?

This is an entry door threshold weather stripping that slides or pushed into the bottom of door with the two upright inserts. Inserts set 1 inch apart. Bottom plate to the bulb is 1 1/2 inches, bulb is on inside edge.

Hi, looking for the door sweep for our old wood pella slider.it has 2 grooves the hold the sweep this is inside at the floor.The lock is in the door but no thumb latch. The slider is an XOThanks, Tim

Does this show what I need?

Looking for a bottom door sweep for a Celco Plus 1185-L door, the sweep is completely disintegrated so can not even tell what it was supposed to look like. Thank you for you assistance, it is greatly appreciated.