Viewing all customer Discussions for:

58-186 48" Duo-durometer Door Bottom Sweep

I have a 72X80 stanley steel double entry door Model 251271. I need one sweep for the door bottom. Plus I either need the wooden part of the threshold or the entire 72" long threshold assembly. Are these parts available? Thank You David

Looking for the door sweep, top and sides weather-stripping for patio door. Can pay to expedite if possible

I have this door t-slot bulb bubble seal that has a width at the t-slot of 1/4" and the bulb circumference of about 1/2".8 cannot find it anywhere.

Looking to identify this door bottom weather striping so I can get a replacement insert. Any ideas?

This is an entry door threshold weather stripping that slides or pushed into the bottom of door with the two upright inserts. Inserts set 1 inch apart. Bottom plate to the bulb is 1 1/2 inches, bulb is on inside edge.

Hi, looking for the door sweep for our old wood pella slider.it has 2 grooves the hold the sweep this is inside at the floor.The lock is in the door but no thumb latch. The slider is an XOThanks, Tim

Does this show what I need?

Looking for a bottom door sweep for a Celco Plus 1185-L door, the sweep is completely disintegrated so can not even tell what it was supposed to look like. Thank you for you assistance, it is greatly appreciated.

Good morning, hope you guys can help. I've been looking for several hours cannot find one to match mine. The Doors are older National Industries Incorporated doors 1989 vintage .They snap in width is 1 3/8" between the the snap in pieces, it has 2 square Bulb type and 1 flat center fin in the middl ... (cont.)

I am looking for a replacement for this Pella patio door bottom. As you can see, the right side of the seal is damaged.

this is a custom pella door i can not identify this seal i had sent you an email to help at swisco.com many thanks Mike

I have white in-swing, both sides open, Jeld-Wen patio doors that are solid wood with a covering that I assume is steel. The markings are NFRC 100/200 Series Doorcraft Steel W/E door MST 3068. The doors are 34.25 inches wide with a 0.75 inch strip attached to the right hand door. The height of the ... (cont.)

I was just looking at your site, to see if I could order a 48 inch bottom door sweeper replacement 48 inch is hard to find, Home Depot and Lowes don't carry....enclosed is picture I was going to order 58-190 48.25 high Performance one, I believe it's glued on won't know till I take the door off, is ... (cont.)

Hello: Our front Entry Door has gradually developed a space between the door sweep and door threshold. Our current sweep measures 42 inches long and 1 & 13/16 inches wide. Our current threshold is 5+ inches wide and 41 & 1/2 inches long between the door jambs although the space in front of the doo ... (cont.)

Can you help me id this lower door sweep,please. If you have a replacement? thank you

I have a french door that needs a new door sweep. Cant find any markings on door. This is tacked on the bottom of the door. Where may I get a replacement for it or suggestions of what to do ? It is an exterior door.

I need to replace the door sweep for my Pella french door, right hand side. I can not locate the model number anywhere but I've been told by Pella that the french door was manufactured in 2008.

I am looking for bottom sweep style weather stripping for our solid wood front doors - please see pictures attached. They are French style doors so I will need for both

We need the weather strip that goes around the door and attached to the bottom of the door

please help me find a replacement door bottom for my 20 year old Milgard French doors.Thanks Brian