Viewing all customer Discussions for:

26-439 Tilt Latch Pair, 2-7/16"

1 1/8 x 3 1/2 are the dimensions can you please help me match this Thank you very much also thank you very much You've been extremely helpful in the past as well.

There are no numbers on the part. I need to edit it spring loaded for a tilt remove window.

spring slides to open windows for cleaning or easy removal of bottom window section

No markings

PAT. # 4,901,475

This is for the lower window to unlock it so it can swing inward for cleaning. Window is about 13 years old.

We have Simonton windows that were installed around 1999. Do you have a replacement for the tilt latch. Our's is W 15/16, L 3 1/2, H 5/16 .... Screw to Screw 2 9/16

Whole piece is 3.5 inches. Drill holes are 2 inches apart. Off white color. Pegs are broken off. There are no identification on them.

Hello I have a single hung window I replaced the spiral balances on the window but i need this part. I need a left and right if possible, please.

I don't see any information on my part. I have only the dimensions shown in the pictures. I would like to get a quote on a dozen pairs

I need two of these... one for the left and right sides. Also in need of a Head Expander for a 38 1/2 x57 replacement window TTT. White grids 6 over 6

Looking to replace the window balances in PGT SH 1400 bt single hung windows. the balance rod is 5/8" wide 29" long. there are no marking on the existing balance. the clips that hold the bottom of the ballance spring and the window also need replacing. I could not see a color on the bottom of the e ... (cont.)

I need to order a few of these window locks. Please let me know what the part is. Thanks

My original has screw holes are roughly 2"-2 1/16th" appart. And the overall width is 1" 2/8th". If you would have anything closer to those measurements, could you please forward the images.

Owen Corning window. 1995? 3 1/2" Center screw to center screw 2 5/8

Owens Corning fiberglass windows from late 90's 3.5" long 1" wide at base has lip on top that over hangs window recess 2 9/16 center to center screws5/8 center screw hole to front pat # 4,901,475

I am looking for these window parts Any help or guidance would be appreciated. Thanks Jay

I'm looking for a replacement for a right-side flush mount tilt latch as shown in the attached photo. The window is made by Owens Corning. "Patent # 4,901,475" is printed on the underside. There is no other writing on it. Any assistance in finding a replacement would be great. Thank you in advance! ... (cont.)

2 7/16" center to center holes on tilt latch. Need 4, 2-Left and 2-Right.

Looking for the left window tilt latch made by GA Pacific. I have attached photos of the original and hoping you can provide a replacement. Thank you in advance.