Viewing all customer Discussions for:

26-275 Window Slider Limit Lock

I am looking for below stopper for the vinyl single hung window called Allied. Can we still get one? Please advise. Thank you.

We need these replacement parts for our Alumax windows.

This part has a centre tab that can be pushed up or down to stop window from opening wider than 3 inches. No part numbers on piece made of plastic. Screws to window frame.

I am looking for a vent stop for a Traco sliding window.

Trying to find out what exactly this part is called on my Certanteed vinyl windows.

I have a Certaineed window and I'm looking to purchase this security piece for the window. It allows the window to open about 4 inches. can you help? Thank you Jeff

We have Alpine vinyl window and many of our locks are broken. Looking for this tiny part it is 2 3/4" long and 1/4" wide. The windows are 25 years old.

Hi Swisco-First off, thanks for being the amazing window parts resource! Hopefully you can help me here. I have a customer that is looking for a more safe and secure way for keeping their aluminum single hung lower storm sash up in the open position. The current keeper system is a thumb screw only o ... (cont.)

This is an XOX Certainteed Window. The small lock that restricts how much the right sliding window panel can open has cracked. Photos attached. Is there a replacement available?

I need the "stop" that folds over to keep window from opening as seen in the photos. I only need the stop not the latch. Thanks!

I'm looking for the PART NUMBER for this old cascade windows 04/05 keeper. Can anyone give me some insight?

Hello I was hoping you could help find a replacement for our window slider lock. The spacing between the screws holes is 2 1/8 inches. I see you have other with a little larger spacing but would prefer not to drill extra holes. I am looking for 6 units. thank You Michael

No names or markings on these. Old (1994) Alpine windows. Most of the stops have the stem that swings out to stop the window from being pushed up all the way have broken off. measurements: 2 3/4" long and 1/4" wide. 2 1/4" from center of top screw to center of bottom screw

Hello, I am looking for replacement parts for the piece in the pictures. It is used to stop the window from opening wider than a few inches. I can't seem to locate it on your site. Any idea what it is called or where I can get it? Note that a small part of the piece in the picture has been chipp ... (cont.)

Latch along sliding window to limit its opening

Good morning, I am looking for about 220, sash limit stops for some horizontal sliders. I came across your website and saw your product number 26-275, and 90-270. If you have something else that would work best, I am open for suggestions. Thank you,

Looking for security stop like model 26-275, except it's 1 1/2" screw hole to screw hole. This is on a Traco vinyl sliding window. Thanks

Hi, I too need a few Certainteed parts for my windows. They are the side locking mechanism and a second lock that screws to the frame to provide a secure way to have the window partially open. Any help would be appreciated.

Recently I went out on your website to look at some of your products. What I found was just about what I thought I needed for my windows. But I have questions. My vinyl windows were built in 1986 as far as I can tell and are at a point where we have replaced seals (glass) because ... (cont.)

I am looking for vent locks for existing vinyl windows that do not currently have vent locks. Can I install 20-013 on vinyl windows? I know that it says for wood windows, but I am wondering if they would work for vinyl and if I need to do anything special to install besides predrill. I know that ... (cont.)