Viewing all customer Discussions for:

87-221 Tandem Roller Assembly, 7/16" Brass Flat

hi there , can you pleas verify what type of wheel is it? you can let me know a few options if you are not sure, i dont have any information on the window type.

I need four pieces

I have vinyl glider windows wit two sets of brass roller for each window. The rollers have worn down. I have attached the dimensions. The nylon housings appear to be in good shape the rollers are 9/16 with a 3/8 pin

I have attached pictures of my horizontal "CWS" brand window rollers I need to replace. I did order 16 --- 87-190 Double Roller Assemblies (Order #87-190) from Swisco. They do fit into the slots correctly but the rollers are not high enough to allow the window to roll. It is like there are no roller ... (cont.)

There are two rollers in the top and bottom of each window. Currently a few of the windows squeak a lot when opening and closing. The tracks are cleaned and I put a silicone based lubricant on the track but after a short period some windows start squeaking so I want to try replacing a few rollers to ... (cont.)

I have these rollers and need to identify them. House was built in 2000. I think this has one side that broke off.

There is 1 roller and its plastic goes on a custom made slider on my porch.1/2 inch x 2 amd 1/8 long x 3/4 deepMike

I have Philips windows these are the nylon rollers at the bottom. They need to be replaced. Thanks

Hi There, what type or rollers are these? Thanks, Robert

I need Norandex sliding glass window wheels

These windows are A 1970s vintage, I don't know the manufacturer. I have about 20 windows. Can you identify a match for these roller assemblies?

I need to find two replacement rollers for the bottom of a large Jel-Wen sliding window. I purchased a different Roller Assembly but I now see that it is approximately 2 cm too long to snap into the two existing rectangular slots on the window (existing = 3.4 cm, new part = 3.6 cm.) I need to either ... (cont.)

Manufacturer: Penguin Windows (No longer in business). Series: Maxuus 10

it says Saunders Engineering on the bottom of the part

Hi, I just replaced all of the channel balances on my windows, and they are all working great now. Thank you for your great products!I need 6 new Sliding Window Rollers With Plastic Housing.The roller housing is 1 3/8 inches.The wheels are brass and flat.There is a lip around the edges on all sides, ... (cont.)

No parts number

Need to replace rollers, only info on window I can find is "ABC" on the latch. Appear to be brass 1/2 dia. by 1/4 flat width. Could replace assy. or just wheels and axles. Please let me know if you need more measurements. 87-190 matches better but I don't think 1 1/2 length will fit (mine is 1 3/8) ... (cont.)

I tried the 87-036 in the past and it didnt work. Would you be able to send me one to check the fit with the new style? I'm going to need 16 of them so I don't want to order the wrong size.. Thanks Phol

I need replacement sliding window roller replacement plastic housing with medal roller Ed

Wondering if you can help me find the replacements for the rollers pictured above? There is one on you site that I think will work but it seems like it might be a little small. Thanks for the help. Alan