Viewing all customer Discussions for:

33-097 Phillips Pan 10-24 x 9/16" Self-Tapping Machine Screw

The lock latch is broken, wont catch (very loose). I believe the measurment is 4 3/4.the outside crank handle is cracked (see photo). I have 2 of each on my bay window and would like to replace them. Can I just replace the handle or the whole assy? is there a how 2 video on repairing this? what woul ... (cont.)

I need 2 of these. What are they? Can you help?

arm that grasps pin is broken.

Do you have this window hardware? This is a crank window that was purchased in 2006. Thanks Annette

Hello. The latching mechanism is not working on a CA5540 window. Please advise which replacement part needs to be ordered. Thank you.

need white cover for the operator and new handle need piece that attaches to window need complete locking hardware and handle part too

Does the casement lock comes threaded? Or are you required to buy the self tapping screws?

I have sent 3 pictures from an operable window lock mechanism for Milgard crank windows. I need to replace two that have a broken lock handle. Am I correct in assuming that the lock handle will fit either left or right locking?

Left hand, locking window latch

Hello, I'm looking to replace the window crank sets, covers, handles, and locks for a right swing and left swing window all in beige. Thank you! - Amber

Hoping you can point me in the direction of which replacements I should order, please and thank you!!

I have used the 81-030 Acorn Sliding glass door rollers for years. The original screw I have that fastens the roller to the door is too large to fit into the threads on the glass door roller.What size/type of screw do I need?Steve

Can you tell me the size screws needed for this part? TY

I need replacement sliders for a Reliabilt 4444467 from lowes. I think the 81-030 might be it. I just bought the door but these already appear to be a consumable component. I wonder do the mounting screws shown 33-097 attach these rollers?

Is the hole in the top tapped for a 10-32 machine screw? I am looking for a double roller similar to a Slide-co 131300 double roller.

This is a photo of the roller I modified in order to keep it moving. I can't find any identifying marks on the roller, or the door, which is custom built 8 1/2 feet tall by 4 1/2 feet wide. It was installed 35 years ago and we cannot find anyone from the original builder to help. I didn't measure ... (cont.)

I need help locating the latch for this awning window. Can you help me out I attached some pictures. Please let me know if you can help. Thanks Steve B.

I believe this is the proper lock that I need. These are the dimentions of what I have: 4 1/2" total length 11/16" total width 3/8: insertion section width screw holes center to center 3 13/16' color beige Do you need any other dimentions? Pictures attached.