Viewing all customer Discussions for:

95-262 Square Cut Screen Corner

Plastic corner for screen window, 783 stamped on it.

I am looking for frame corners for window screen. Looks to be 5/16 x 6/16. Only need a small pack. Thank you for your help

Hello there. I hope you still have these. I'd like to keep original if possible, but any that will work will be fine. The parts I've seen in your discussions don't quite match these. They came from unknown windows, probably Champion. From about 2005?

Hi, I'm trying to locate four 5/16" corners that match this one. Note the stepped offset on portion that is inserted into the frame.

#782

There are no markings, numbers or branding that I can find, either on the corners or on the frame. Note the unusual offset plastic 'channel' on the low inside edge, and the row of comb-like 'fins' on the main outside edge. TIA

Hello. I included pictures of the old corner and the new corners I received today. The new corner is incrementally smaller and that causes the side rails to be short and not sit fully in the window tracks. I could replace all the side rails of course with slightly longer pieces but that defeats my t ... (cont.)

We have a lip screen with 4 broken corners - 2 top, 2 bottom (the tops have the extra nub - see side view photo of the 2 ). Bottoms both broken, the one broken piece. They seem to be slimmer than our average corner by about 1/16.

No markings on these corners

I have attached the photos. 7/8" long 5/16" depth. Will 95-218 and 95-262 fit for this replacement. Thanks

Could you recommend a replacement for the corner piece in the attached photos?

I need plastic screen corners. MY existing ones have a 782 number on them. I need 2 regular ones and 2 with a stop.

please identify

I need to replace the 4 corners to my Champion Windows screen frame. They're 19 years old, and the frame's thickness is 1/4" not the standard 5/16". I'm afraid They're going to be proprietary pieces. Do you sell or can you recommend a source to purchase about 4 of them? Champion Windows Customer Ser ... (cont.)

the picture is of a Stanley window screen upper corner insert with pull and latch. The number 842-2A is stamped on the latch tab that slides up and down. I am also looking for the bottom corner inserts w/o the pull or latch. The rolled screen frame is 3/4" wide X 5/16" thick.

I purchased 95-263 and 95-262 to make up some screen frames. I thought they fit into a 5/16 frame but it seems that they're sloppy. In the picture with the three corners the plastic corner that is not yours does fit snug. Did I buy the wrong ones? Is there a specific frame to go with these? (I'd rat ... (cont.)

I need 2 corners

This corner is a bit thicker than your #782. I think it?s the next width up. Do you have anything that next size

Your picture doesn't show the inside dimensions of the leg of the corner going in to the frame.The one I am looking to replace has the flange at appx. 17/32 with the inside at 3/8.

I have tried both of your connectors part #95-112 & #95-031. Neither would fit. They were too big but just barely. Any help you can give me would be great. I would need 20 connectors. Thank you, Carolyn