Viewing all customer Discussions for:

81-282 MI Patio Door Roller, 1-1/2" Dia. Concave BB

I have measurements that seem like this part is the right one. I believe it is Patio Roller Assembly, 1-1/4" Steel Ball Bearing Part # 81-279 I am sure on the 1 1/4" metal roller 2.5: case (which shows 2.58 in your drawing and I could be off that much)and the 1 3/8" height. Just checking for your ... (cont.)

I had to pry out the roller the device was being held inside the door frame by a screw mounted in the frame ( see top of roller part)

W 3/4" H 1-1/8" Steel wheel 1-7/16" Unlike all the YouTube videos, these where held in place by a screw through the removed bottom piece. FWIW, this is on a mid 90's mobile home patio door. Need replacement as soon as I can find them.

These are from a patio door manufactured in the mid 1980s

This is the roller off a 7 foot sliding patio door that is 50-70 years old.

1 &1/8 inch wheel diameter, 1 & 1/4 inch wheel width, casing that holds wheel assembly is 1 & 3/16 high by 11/16 wide, by 2 & 3/8 long, with 1 adjusting screw at bottom to raise and lower wheel. Top of wheel casing has screw hole just to the right of centre on top to screw wheel assembly to bottom ... (cont.)

I recently purchased 3 sets (6) wheels of item # 81-258 Adore Hi-Lite series 1200 Patio Door Roller Assembly However, they're the wrong size.Attached: are Pics of the correct wheel assembly in hopes you can find what I need.I will return 2 sets (4) wheels back in exchange for the correct wheels.Tha ... (cont.)

Need new rollers for sliding glass door wheels are 1.5 inches, width 3/4", and length 2 1/2 inches.

This door was installed new when the hose was built 20 years ago. The pictures are taken on 1/4" graph paper(I think). Unfortunately I did not measure anything or put a ruler in the pics for size (uhg!)

Please let me know if you carry this assembly. Thank youBob

Single roller, unsure of wheel diameter at this point. This is a heavy alum door and window

Need 6-8 replacements to match as close as the photos

Can you identify this part number for me?

We have an "ANSI AAMA 101-85 SGD-R20, Series M-800/M825/M850 door". We are needing replacement rollers for the glass sliding door, bottom.

Looking for replacement rollers for glass door that are about 50+ years old, hopefully these photos will help to identify the parts we need, thanks for your help

Rollers 2 only on bottom of door. Held in place by screw from edge of door and one from above. Markings: Row 1 "A-S" Row 2 "MYC" Row 3 "7867" Thanks for help locating part. Zack

Looking at the Del Mar web site, I believe this unit is SKU#F3727. I'm pretty sure this is a 1 1/4" wheel. These are used in a pool environment, and the doors become very hard to open or freeze up after a few years. We need 10 of these units. Would stainless steel or nylon wheels prevent this? ... (cont.)

Single roller part number Delta 1165 Is there a replacement to this model

Hi, I need to replace the rollers shown in the attached picture for 18 sliding glass doors for a total of 72 rollers (one set of rollers is duplicated). The original hardware shown comes from a 1962 home and only marking found were the name "KILIAN"

I can not find a similar roller.