Viewing all customer Discussions for:

82-086 Legacy Keyed Handle Set, 3-15/16" (1-1/8" to 2-1/2")

Hello, I'm looking for a matching handle to install to fit an 82-265 mortis latch. I'm unable to find this as I have two doors so I would need to find this exact part to have matching doors. Thank you for your help in advance.

Looking to replace the patio door handle lock.

Hello, I am actually looking for the locking mechanism for this particular handle. I can't find it anywhere. I have seen some similar to it but they are smaller. I'm ready to purchase. Thank you. Ed

I need a new sliding door handle. Made by Sash Controls. Do you have? Approx cost? Thank you

Silverline (label in photos) of door handle is loose, cracked and bottom bolt thing is pulled thru on outside.

Purchased Part #82-086

We have this sliding door in our house and i cant figure out the manufacturer to get replacement parts. The handle recently broke and we have tried lowes and home depot with 0 luck. The color match is also a huge issue. From the stickers on the door we capture ALI ADW-8 ASTM 2190. ... (cont.)

Hi?you guys bailed me out last time I needed a part, I'm hoping you can help me out again. I just need the base part that the handle attaches too and the lock goes thru as in the picture. Can I just get that piece or do I need to buy the whole handle? I just got the lock latch from you a few months ... (cont.)

Door labeled as ALI ADW-8 ASTM 2190-ARG Need new handle and lock mechanism. Photos attached. Thank you

The lock snib broke on our Milgard Essence sliding door, and since the finish on the inside handle has worn off over the years, we were thinking about replacing the entire handle.Is this handle set compatible with a Milgard Essence sliding door? The dimensions match exactly, and I've attached a phot ... (cont.)

We have a 2 point door lock on our sliders that need replacement. See attached photos and measurements.The door product number from atrium is 332. Thanks Mark I looked at your product # 82-265. but was not sure if it would work?

I have the the nfrc adw-m-400 sliding door. The upper of the two locking hooks is broken . Can someone ping me in the right direction for a replacement. Is it under warranty being 2 years old ?just wondering . Thanks !!

Hi can you identify the part I need to replace this handle?

The thumb turn(shown in the extreme right pic has broken and needs replacement or a handle set to retrofit to the existing lock is required. Mortise lock is not required.Would you be able to assist me to repair the thumb set or replace the handle set? This request it urgent.Thanks Eric ... (cont.)

Looking for sliding door lock mechanism ours has jammed.

Hello, I am looking to add an exterior keyed lock to an existing sliding door. I have excluded photos of the door model as well as the multi point mortise. Is there a handle set that will work with the existing mortise? I have measured the spacing and the holes on the handles are 3 15/16. I looked t ... (cont.)

i need a new handle for this door, because the locating mechanism is broken. do you have replacement parts? if you need more info let me know ? i didn't know how to identify the code etc

Handle failed

This is an eight year sliding door. The handle is broken and I'm looking for a replacement. Can you direct me to where I could find one.

ctg tempered 16 cfr 1201 11 sgcc 1921 1/8u ansi z97 1-1984