Viewing all customer Discussions for:

82-086 Legacy Keyed Handle Set, 3-15/16" (1-1/8" to 2-1/2")

Need new lock for sliding door. Please send part numbers and price.Inside latch L 12.5"W 1"Inside L 11"Inside W 3/4"Top screw hole 1/4"Top inside screw 1 1/4"Top inside second screw 3.5"Top bottom inside screw 7.5"Bottom inside screw 10"Bottom latch screw 12"Door handle holesTop 2.5"Middle door han ... (cont.)

Hi. Looking for a replacement sliding glass door kit.Reliabilt door 332Double latch with key lock.Please see photos for dimensions. Thanks, Carl

lock is part of a door from Simonton Windows/Owens Corning maybe named: K0038 3/23/03

Looking to add lock to existing door handle OR purchase a key lock set of handles for patio door Watched video regarding adding a key lock however they mention a punch out hole for the key lock and the existing handle does not have the punch holes. The existing latch is offset and was installed i ... (cont.)

Delaney latch is broken

Want to make sure you send me the right part. I hope this information will tell you what part I need. Thank you very much for helping me with my problem. The part that broke is the locking lever.

does a 82-086 work with 82-265 face plate with a 82-249 point keeper

Hello, I'm looking for a matching handle to install to fit an 82-265 mortis latch. I'm unable to find this as I have two doors so I would need to find this exact part to have matching doors. Thank you for your help in advance.

Looking to replace the patio door handle lock.

Hello, I am actually looking for the locking mechanism for this particular handle. I can't find it anywhere. I have seen some similar to it but they are smaller. I'm ready to purchase. Thank you. Ed

I need a new sliding door handle. Made by Sash Controls. Do you have? Approx cost? Thank you

Silverline (label in photos) of door handle is loose, cracked and bottom bolt thing is pulled thru on outside.

Purchased Part #82-086

We have this sliding door in our house and i cant figure out the manufacturer to get replacement parts. The handle recently broke and we have tried lowes and home depot with 0 luck. The color match is also a huge issue. From the stickers on the door we capture ALI ADW-8 ASTM 2190. ... (cont.)

Hi?you guys bailed me out last time I needed a part, I'm hoping you can help me out again. I just need the base part that the handle attaches too and the lock goes thru as in the picture. Can I just get that piece or do I need to buy the whole handle? I just got the lock latch from you a few months ... (cont.)

Door labeled as ALI ADW-8 ASTM 2190-ARG Need new handle and lock mechanism. Photos attached. Thank you

The lock snib broke on our Milgard Essence sliding door, and since the finish on the inside handle has worn off over the years, we were thinking about replacing the entire handle.Is this handle set compatible with a Milgard Essence sliding door? The dimensions match exactly, and I've attached a phot ... (cont.)

We have a 2 point door lock on our sliders that need replacement. See attached photos and measurements.The door product number from atrium is 332. Thanks Mark I looked at your product # 82-265. but was not sure if it would work?

I have the the nfrc adw-m-400 sliding door. The upper of the two locking hooks is broken . Can someone ping me in the right direction for a replacement. Is it under warranty being 2 years old ?just wondering . Thanks !!

Hi can you identify the part I need to replace this handle?